Welcome Congratulations on your purchase of this Uniden WDECT2305 optional handset and charger. This additional handset is for use with the Uniden WDECT2315 and WDECT2355 base. You can place a fully featured cordless handset anywhere in your home where AC power is available to connect the handset charging cradle. THE WDECT2315 and WDECT2355 SERIES WILL SUPPORT UP TO 4 HANDSETS. IMPORTANT The WDECT2305 will not operate unless it has been registered to a Uniden WDECT2315 or WDECT2355 series. Befor

Choosing the best location for your phone. When choosing a location for your phone there are a number of appliances the phone should not be near, and areas you should avoid. AVOID - 3 AVOID connecting more than phones as ringing may be impaired AVOID multi power boards. CHARGE the new phone for 15 - 20 hrs. AVOID Moisture Don’t overload the power outlet. AVOID - moisture Television sets and other electronic appliances AVOID - Microwave ovens AVOID - Computers AVOID - other cordless telephones CH

1. Plug the AC Adaptor into the power socket at the rear of the DTAM labelled “9 V AC 400mA”. 2. Then plug the other end into your mains socket. appear to indicate that no outgoing messages are recorded. When you first connect power, the DTAM beeps once and announces "Please wait". The message counter counts up from 0 to 18. Then the DTAM beeps. , , , and alternatively NOTE: The display will flash if there is no back up battery fitted or if the back up battery is low. BACKUP BATTERY If the power

. . . . . . . . . . . . . . . . . . . . . . . . .1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Parts Checklist . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Installation Selecting a Location . . . . . . . . . . . . . . . . . . . . . . . . .6 Connecting the 7500AI to the Telephone Line . . . . . . . 6 Connecting Power . . . . . . . . . . . . . . . . . . . . . . . . . .

If the interference goes away, your pager is causing the interference. Try to eliminate the interference by moving the pager away from the receiver. If you cannot eliminate the interference, the FCC requires that you stop using your pager. Modifying or tampering with your pager’s internal components can cause a malfunction and void your FCC authorization to operate it. If your pager is not performing as it should, contact your pager service. This device complies with Part 15 of FCC Rules. Operat

If the interference goes away, it was probably caused by your pager. To eliminate the interference, move the pager away from the affected device. If the interference cannot be eliminated, the FCC requires that you stop using your pager. Modifying or tampering with your pager’s internal components can cause a malfunction and void your FCC authorization to operate it. If your pager is not performing as it should, contact your pager service. This device complies with Part 15 of FCC Rules. Operation

• Base unit (1) • Handset (2) • AC adapter (2) • Rechargeable battery (2) • Telephone cord (1) • Beltclip (2) • Charging cradle (1) • This owner’s manual • Other printed materials Uniden Parts Department at (800) 554-3988 Hours: M-F 8:00 a.m. to 5:00 p.m. CST. We can also be reached on the web at TO INSTALL THE HANDSET BATTERIES A Remove the cover. Connect the battery pack connector with the correct polarity. Replace the cover. Plug the AC adapter cord into the base unit and charging cradle and

(positive or negative ground). Current Drain Transmit: AM full mod., 2.2A; SSB Maximum output,2A. Receiver: AM & SSB with maximum audio output, 0.6A. Cabinet Dimensions 7-9/32(W) x 9-5/64(0) x 2-9/32(H) Weight 4.5 Lbs Antenna Connector UHF, SO-239 Semiconductors 47 transistors, 5 integrated circuits, 66 diodes and 6 light emitting diodes.. Meter Illuminated; indicates relative power output and received signal strength, green receive LED. Indicators LED display; channel, emergency channel, TX/ RX

The Electronic Communications Privacy Act of 1986, as amended, makes it a federal crime to intentionally intercept cellular or cordless telephone transmissions or to market this radio when altered to receive them. The installation, possession, or use of this scanning radio in a motor vehicle may be prohibited, regulated, or require a permit in certain states, cities, and/or local jurisdictions. Your local law enforcement officials should be able to provide you with information regarding the laws

FEATURES • Depth Readings – The QT-206 is designed to give depth readings from 2.5 feet to a maximum depth of 199 feet. Depth readings are in 1/10 foot increments from 2.0 feet to 15 feet, and are shown as whole numbers up to 199 feet. These readings are displayed on a large Liquid Crystal Display (LCD). • Night Viewing – The QT-206 is back lit at all times with a soft glowing lamp designed to help your night time navigational needs. 2 INSTALLING THE QT-206 1. Find a location on your dash panel