Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  

Aztech Systems TX 2

downloaded: 1File size: 317 kb    Manafacture: Aztech Systems  
Category: Power Screwdrivers and Drills

8. Using the End Plug Wrench (21), thread the assembled End Cap, o-ring end leading, into the piston end of the Housing and tighten it. 9. Wrap the threads of the Swivel Sets (18) with Teflon tape and thread the swivel with the male hose Coupler (19) into the center of the End Cap. Thread the Swivel with the female Coupler into the hole in the Housing directly above the End Cap. Assembly of the TX-2, TX-4, and TX-8 Cylinder Assemblies 1. Grasp the link retaining pin lug in copper-covered, vise j

Aztech Systems 8

downloaded: 0File size: 317 kb    Manafacture: Aztech Systems  
Category: Power Screwdrivers and Drills

Any nicks or scratches to the surface will allow hydraulic oil to leak from the Cylinder when the tool is reassembled. 6. Sprag the flat end of the piston shaft against rotation and using a socket on the hex of the piston head, -10 unscrew and remove the piston head from the shaft with the Piston O-ring (17). 7. Pull the Piston shaft out of the Housing. 8. If the Sliders (5) must be replaced, position the Slider Pin (14) over a clearance opening in a soft block and use a small drift to tap the P

Aztech Systems 4

downloaded: 0File size: 317 kb    Manafacture: Aztech Systems  
Category: Power Screwdrivers and Drills

Always wear eye protection when operating or performing maintenance on this tool. DISASSEMBLY General Instructions 1. Do not disassemble the tool any further than necessary to replace or repair damaged parts. 2. Use extra care not to score, nick or damage surfaces that will contain hydraulic oil under pressure. 3. Whenever grasping a tool in a vise, always use leather–covered or copper–covered vise jaws to protect the surface of the part and help prevent distortion. This is particularly true of

Aztech Systems 32

downloaded: 0File size: 317 kb    Manafacture: Aztech Systems  
Category: Power Screwdrivers and Drills

WARNING IMPORTANT SAFETY INFORMATION ENCLOSED. READ THIS MANUAL BEFORE OPERATING TOOL. IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PLACE THE INFORMATION IN THIS MANUAL INTO THE HANDS OF THE OPERATOR. FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY. PLACING TOOL IN SERVICE • Always operate, inspect and maintain this tool in accordance with American National Standards Safety Code for Hydraulic Rams and Jacks (ANSI B30.1) • This tool will function using an air or electric powered h

Aztech Systems 16

downloaded: 1File size: 317 kb    Manafacture: Aztech Systems  
Category: Power Screwdrivers and Drills

If the notch in the piston rod did not engage the Retract Pin in the Ratchet Link when the Link was joined to the Housing, it will engage the Pin automatically during the first advance stroke. 4. When the Link is connected to the Housing and the wrench is started, the reaction surface of the wrench will move against the contact point and the nut will begin to turn. 5. When the nut is no longer turning and the Pump Gauge reaches the preset pressure, release the remote control button. The piston r





Category