3. Adjust the engine to a low speed until you see water exiting the water outlet. NOTE: This may take up to 3-5 minutes. Adjust the engine throttle back to full RPM. 4. Once the unit is primed, stop the engine and connect the high pressure discharge hose to the water outlet of the unit. NOTE: The trigger gun and dual lance assembly should already be connected to the high pressure discharge hose at this time. START-UP/COLD WATER OPERATION: 1. Refer to the "Safety Precautions" pgs. 4-7 before star

Developed to ensure Optimum Performance andProtection. IMPORTANT...Use Year Round! 341904 012011 Warning: This product contains lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash your hands after handling this product. INTRODUCTION Congratulations on the purchase of your new John Deere hot water pressure washer featuring the patented Electro Magnetic Firing (EMF) System! You can be assured your John Deere hot water pressure washer was constr

If this product contains a gasoline engine: WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. The State of California requires the above two warnings. John Deere Merchandise Division 00-99-000458/904 Litho in U.S.A. Introduction Foreword THANK YOU for purchasing a John Deere product. WRITE PRODUCT INFORMATION in the Specification section. Accurately record all the numbers to help in READ THI

WARNING: Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known by the State of California to cause cancer and reproductive harm. Wash hands after handling. IMPORTANT: DO NOT plug battery charger into power receptacle or set any charger controls until ALL connections have been made. Turn all vehicle switches OFF (ignition, lights, radio, etc.) before connecting battery charger. Turn all battery charger and time switches OFF before connecting battery ch

Wash filter assembly in clean fuel and inspect for damage. Note: It is not necessary to remove filter from filter assembly on Model T70. On Model T115 and T165 assembly is one piece. 5. Install filter assembly and bushing (Model T70) into fuel tank. IMPORTANT: Be sure filter (Model T115 and T165) and bushing (Model T70) are firmly seated in tank. 6. Connect fuel line and install side cover. Model T70 B C A Model T115 and T165 C A B 107351-01 19 Periodic Service STORAGE LOCATION AND MAINTENANCE N

It has only information you need for normal operation and maintenance. If a technical manual is desired, see your John Deere dealer for the correct manual. USING SERVICE RECORDS 1. Keep a record of the number of hours or operation. 2. Check your record regularly to learn when service is required. 3. Do all the services in the interval section. Then write the number of hours (from your service record) and the date in the spaces provided. Sample Service Record Chart Date Hours 1 Jun '85 3 6 Jun '8

6. Replace fuse cover. 7. Replace side cover. B C A CLEANING FAN CAUTION: Fan blades are sharp. Carefully work around blades or wear gloves when cleaning. IMPORTANT: Remove fan from motor shaft before removing motor from heater. The weight of the motor resting on the fan could damage the fan pitch. 1. Remove upper shell and fan guard. 2. Loosen setscrew (A) which holds fan (B) to motor shaft (C). 3. Slip fan off motor shaft. 4. Clean fan using a soft cloth moistened with kerosene or solvent. 5.

If more than one heater is used, include equivalent ventilating area. • Provide adequate clearance from people, animals, and combustible materials - 8 feet (2.4 m) from heater outlet; 6 feet (1.8 m) from top; 4 feet (1.2 m) from sides. • Be sure there is no obstruction in intake or output openings. • Be sure heater is on a level, stable surface. • Depending on thermostat setting, heater can start immediately when power cord is connected. • Be sure electrical circuit is adequate and properly grou

Product specification and design are subject to change without notice. Preface AATA International is an innovative and dynamical company, specialised in stair climbing equipment. Stairrobots are active in over 30 countries worldwide. This manual is written for machine operators and for technician who take care for the maintenance of the machine. Although the tiniest details are not set out, the manual is a useful help for people who are dealing with the machine on a daily basis. The stairrobot S

Field cleaning of the sprayer from one job to the next is a good business practice and insures happy customers. Cleaning a sprayer in town requires containment of the spray materials to prevent contamination of local water supplies. The John Deere SprayMaster Power Washer, complete On-Board Hydraulic Powered High Pressure Wash System is designed to make short work of the cleaning process. With 4 gpm @ 1500 psi, 50 feet of high pressure hose, and a trigger gun with a 36'' lance, you can quickly c