00726339C OPERATOR’S MANUAL This Operator's Manual is an integral part of the safe operation of this machine and must be maintained with the unit at all times. READ, UNDERSTAND, and FOLLOW the Safety and Operation Instructions contained in this manual before operating the equipment. C01Cover RHINO® 1020 S. Sangamon Ave. Gibson City, IL 60936 800-446-5158 Email: parts@servis-rhino.com ©2006 Alamo Group Inc. $0.00 To the Owner/Operator/Dealer All implements with moving parts are potentially hazard

(SL-30) OPERSome tractors are equipped with a “Super Steer” front axle. When a loader is mounted to this type of tractor, the bucket will shift in the opposite direction from which the wheels are turned. Maximum shift will be approximately 8 inches and most noticeable when the tractor is stationary. Sudden or unexpected movement of the loader and attachment could result in serious injury to the operator or bystanders. (SL-33) Operate the tractor and loader only in conditions where you have clear

• Store the loader in a clean, dry place resting securely on parking stands at ground level. • Use spray touch-up enamel where necessary to prevent rust and maintain the appearance of the loader. OPS-L-0010_B Parking Stand . OPERATION © 2010 Alamo Group Inc. OPERATION 1585 01/11 Operation Section 4-39 9. Transporting the Tractor and Implement Never allow children or other persons to ride on the Tractor or Implement. Falling off can result in serious injury or death. (SG-10) Transport only at spe

READ, UNDERSTAND, and FOLLOW the Safety and Operation Instructions contained in this manual before operating the equipment. C01Cover RHINO® 1020 S. Sangamon Ave. Gibson City, IL 60936 800-446-5158 Email: parts@servis-rhino.com © 2011 Alamo Group Inc. $0.00 TO THE OWNER/OPERATOR/DEALER All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer

OSHA Training Requirements Title 29, Code of Federal Regulations Part 1928.57(a)(6). Operator instructions. At the time of initial assignment and at least annually thereafter, the employer shall instruct every employee who operates an agricultural tractor and implements in the safe operating practices and servicing of equipment with which they are or will be involved, and of any other practices dictated by the work environment. Keep all guards in place when the machine is in operation; Permit no

4-37 Loader Storage ................................................................................................................................................ 4-38 Transporting the Tractor and Implement .......................................................................................................... 4-39 Transporting on Public Roadways ................................................................................................................... 4-41 Hauling the Tractor and Im

Consult an authorized dealer to determine the proper equipment required. Using adequately sized chains, heavy duty straps, cables and/or binders, securely tie down both the front and rear of the tractor utilizing the proper tie down locations as specified by the tractor manufacturer. OPS-U- 0025 OPERATION © 2011 Alamo Group Inc. OPERATION 11. Troubleshooting Guide TROUBLE Loader slow or will not lift POSSIBLE CAUSE Hydraulic oil too heavy. POSSIBLE REMEDY Change to proper oil. and/or dump Oil fi

Remove cap slowly to relieve pressure before removing cap completely. Stay clear to prevent scalded with hot oil that may spray out of the tank that is pressurized and may cause serious injury to eyes, face and exposed skin. HYDRAULIC PUMP/OIL RESERVOIR • Check oil reservoir level and oil condition. (Add specific type oil if low) • Change hydraulic oil filter and hydraulic oil according to maintenance schedule. • Ensure there are no oil leaks and fitting are properly connected • Inspect overall