5 Dryer Operation .................................................................................................................................. 6 Emergency Stop ................................................................................................................................. 6 Safety Precautions ............................................................................................................................. 7 Chapter 2 Safety Alert Decals .........................

PNEG-67. Series 200. Autoflo. Fan/Heate. Control Installatio. Instruction. MODEL # 2TF - __ __ - __ __ _. MODEL # 2TFC- __ __ __ __ _. MODEL # 2TAF - __ __ __ _. This equipment shall be installed in accordance iwth the current INSTALLATION CODES FOR GAS BURNING APPLICANCES AND EQUIPMENT, CAN1_B149.1 and B149.2, or applicable provincial regulations which should be carefully followed in all cases. Authorities having jurisdiction shuld be consulted before installations are made. 2000 Autoflo. TABLE

2) If the bin is 2.66” corrugation the hole should be centered on an outside hill. 3) If the bin is 4.00” corrugation the hole should be centered on an outside valley. 4) Use the mounting plate as a pattern and drill four 3/8” holes through the sidewall at the swich location so the place can be bolted to the bin. 5) Add foam weather strip around the top and side of the mounting plate. 6) Caulk the underside of the mounting plate, on all sides of the 2” hole, and where the plate meets the bin. 7)

The diagram details the correct main power installation for 220V 1 ph, 230V ph, 460V 3ph, 575V 3ph, and 380V 50hz power supplies. On all three phase systems put the leg with the highest potential difference between that leg and ground ( wild or high voltage leg) on the center terminal (L2) at the motor starter. NOTE: Standard electrical safety should be used. (Refer to the National Electrical Code Standard Handbook by the National Fire Protection Association). A qualified electrician should make

1 2 1a 4a 5 3 355 3 354 Right side Left side Frame **NOTE: The parts pointed out on this page are listed on page 7. PNEG-1447 The fan heater end of the dryer is considered by GSI as the front end of the dryer ( theforeground of this photograph is the front end. Right and left sides are labeled above) . Frame Right

5 Safety Instructions ............................................................................................................................... 6 Chapter 2 Recommended Method for Full Floor Installation ......................................................................... 8 Fan Placement Diagram ...................................................................................................................... 8 Grain Systems Recommended Method for Full Floor Installation ...........

5 Emergency Stop Switch .....................................................................................................................6 Safety Instructions..............................................................................................................................6 Safety Precautions ............................................................................................................................. 7 Safety Sign-Off Sheet......................................

Manua. PNEG-37. Fan and Heate. TABLE OF CONTENT. Roof Warning, Operation & Safety ................................................................................. . Safety Alert Decals ..................................................................................................... . 2000 Vane Axial Fans ................................................................................................... . 2000 Centrifugal Fan Service Guide ....................................................

All wire connections 2. Tip clearance on blade 3. Fan blade torqued to torque specs 4. Grill guard in place and tight 5. Motor rotation correct 6. Running amperage 7. Vibration 8. All fasteners tight 9. Indicator light 10. All decals and serial number tag 11. Aesthetic appearance 12. Manual in control box 13. Double check parts in hardware boxes Tester Signature___________________________________________ Date____________________________________ PNEG-524 Roof Exhaust Fan Table of Contents Content

8 EMCS Portable Dryer (1993-1998) Safety Voltage Check Points ................................................................................................................................. 9 Programming Instructions for EMCS Grain Dryers .............................................................................................. 10 EMCS Display Board ............................................................................................................................................ 1