Votes - 2, Average rating: 3.5
(
)
)
|
manual abstract
READ, UNDERSTAND, and FOLLOW the Safety and Operation Instructions contained in this manual before operating the equipment. C01Cover RHINO® 1020 S. Sangamon Ave. Gibson City, IL 60936 800-446-5158 Email: parts@servis-rhino.com © 2011 Alamo Group Inc. $0.00 TO THE OWNER/OPERATOR/DEALER All implements with moving parts are potentially hazardous. There is no substitute for a cautious, safe-minded operator who recognizes the potential hazards and follows reasonable safety practices. The manufacturer has designed this implement to be used with all its safety equipment properly attached to minimize the chance of accidents. BEFORE YOU START! Read the safety messages on the implement and shown in your manual. Observe the rules of safety and common sense! LEA EL INSTRUCTIVO Si No Lee Ingles, Pida Ayuda a Alguien Que Si Lo Lea Que Le Traduzca Las Medidas de Seguridad. WARRANTY INFORMATION: Read and understand the complete Warranty Statement found in this Manual. Fill out the Warranty Registration Form in full and return it to within 30 Days. Make certain the Serial Number of the Machine is recorded on the Warranty Card and on the Warranty Form that you retain. The use of “will-fit” parts will void your warranty and can cause catastrophic failure with possible injury or death. TABLE OF CONTENTS SAFETY SECTION ............................................................................................................................... 1-1 General Safety Instructions and Practices .............................................................................. 1-2 Connecting and Disconnecting Safety Instructions and Practices .......................................... 1-5 Equipment Operation Safety Instructions and Practices ......................................................... 1-6 Transporting Safety Instructions and Practices ..................................................................... 1-11 Storage Safety Instructions and Practices ............................................................................. 1-13 Maintenance Safety Instructions and Practices ..................................................................... 1-13 Concluding Safety Instructions and Practices ....................................................................... 1-14 Decal Location ....................................................................................................................... 1-15 Decal Description .................................................................................................................. 1-17 Federal Laws and Regulations .............................................................................................. 1-19 INTRODUCTION SECTION ................................................................................................................. 2-1 SPECIFICATIONS ................................................................................................................... 2-3 OPERATION SECTION ....................................................................................................................... 3-1 PRE-OPERATION CHECKLIST .............................................................................................. 3-2 OPERATING DIRECTIONS .................................................................................................... 3-2 ENGINE SPEED ...................................................................................................................... 3-2 CONTROLS ............................................................................................................................. 3-2 BOOM/SWING ........................................................................................................................ 3-2 CROWD/BUCKET ...................................................................................................................3-2 LEFT HAND STABILIZER ....................................................................................................... 3-3 RIGHT HAND STABILIZER ..................................................................................................... 3-3 OPERATING BACKHOE ......................................................................................................... 3-3 FILLING BUCKET ................................................................................................................... 3-4 DUMPING BUCKET ................................................................................................................ 3-4 TRENCHING BETWEEN A BUILDING & OPEN EXCAVATORS ........................................... 3-4 SIDE SLOPE EXCAVATING OR TRENCHING ...................................................................... 3-5 MISCELLANEOUS ..................................................................................................................3-6 FINISHING STRAIGHT WALLS .................................................................................