Login:
Sorted: Name ↓   Downloads   Rate   Size ↑  

Nilfisk-ALTO 03KLU

downloaded: 11File size: 292 kb    Manafacture: Nilfisk-ALTO  
Category: Pressure Washers

9 - 16 Betriebsanleitung ................................... 17 - 24 Printed in Denmark Copyright © 2008/2009 Nilfisk-ALTO Congratulations Congratulations on your choice of new cold water cleaner. We are sure that it will live up to your expectations. To ensure that you obtain the best possible results from your new cleaner we ask you to read this instruction manual carefully before use. Yours faithfully Nilfisk-ALTO, Division of Nilfisk-Advance A/S Index EN 1.0 Guarantee .......................

Nilfisk-ALTO 1-20 XT

downloaded: 10File size: 2 mb    Manafacture: Nilfisk-ALTO  
Category: Pressure Washers

Nilfisk-ALTO 111.784

downloaded: 3File size: 3 mb    Manafacture: Nilfisk-ALTO  
Category: Vacuum Cleaners

Keep cord away from heated surfaces. damage when using your carpet cleaner, the following: Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Sears Service Center. Close supervision is necessary when any appliance is used by or near children. Do not allow carpet cleaner to be used as a toy or to run unattended at any time. Do not point tools toward people or pets. Use only commercially avai

Nilfisk-ALTO 114.85925

downloaded: 0File size: 678 kb    Manafacture: Nilfisk-ALTO  
Category: Vacuum Cleaners

9 WASH AND DRY Step on Nozzle Setting pedal if necessary to switch from HARD FLOOR DRY VAC to WET SCRUB & VAC position. Slide Brush On/Off switch to the ON position. Pull Solution Trigger to start the flow of cleaning solution. NOTE; Cleaner will continuously dispense solution until Solution Trigger is released. RNING To r, uce _1: the risk of unplug Injury before from IMPOI hard 4T: When changing between nd carpet cleaning modes, use the correct nozzle: ;leaning -tangerine nozzle ning -green be

Nilfisk-ALTO 2

downloaded: 33File size: 1 mb    Manafacture: Nilfisk-ALTO  
Category: Pressure Washers

CAUTION: Failure to fit the filter will invalidate the guarantee. A clogging up in the nozzle causes a pump pressure which is too high. This is why cleaning is required immediately. 1. Stop the machine and disconnect the nozzle. 2. Clean the nozzle. IMPORTANT: The cleaning tool (11) should only be used when the nozzle is detached! 3. Flush the nozzle backwards with water. pass freely through the machine vents. couplings should be greased regularly. 72 Original Instructions Poseidon 2 EN 8 Troubl

Nilfisk-ALTO 2-19 X

downloaded: 9File size: 2 mb    Manafacture: Nilfisk-ALTO  
Category: Pressure Washers

Nilfisk-ALTO 2-21

downloaded: 7File size: 2 mb    Manafacture: Nilfisk-ALTO  
Category: Pressure Washers

Nilfisk-ALTO 2-21 XT

downloaded: 13File size: 2 mb    Manafacture: Nilfisk-ALTO  
Category: Pressure Washers

Nilfisk-ALTO 2-21 XT

downloaded: 12File size: 2 mb    Manafacture: Nilfisk-ALTO  
Category: Pressure Washers

Nilfisk-ALTO 2-24

downloaded: 5File size: 2 mb    Manafacture: Nilfisk-ALTO  
Category: Pressure Washers





Category