La Crosse Technology®y® Heavy WeatherPro Software User’s Guide (for 2800 series weather stations with USB connectivity) Revision: 1.3 CONTENTSCONTENTS Contents ........................................................................................................................................................................2 Overview..................................................................................................................................................................

Precautions shall be taken when handling batteries. Injuries, burns, or property damage may be resulted if batteries are in contact with conducting materials, heat, corrosive materials or explosives. Batteries should be taken out of the unit before it is stored for a long period of time. Page 5 of 8 La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase,

ADDITIONAL EQUIPMENT (not included) 1) Two fresh 1.5V AA batteries (optional for projection alarm clock) FEATURES OF PROJECTION ALARM Operation of these features is in section III 1. Radio-controlled time 2. Projection of time 3. LED backlight 4. Display of indoor temperature/humidity or alarm time 5. Time alarm ABOUT WWVB (Radio Controlled Time) The NIST (National Institute of Standards and Technology—Time and Frequency Division) WWVB radio station is located in Ft. Collins, Colorado, and trans

2809 Losey Blvd. S. La Crosse, WI 54601 Phone 608-785-7935 Page 1 of 25 Version 2.6 - 9/23/2008 Table of Contents Table of Contents ............................................................................................................................ 2 Congratulations ................................................................................................................................ 4 Quality Forecasts ............................................................................

Note: The following steps often refer to two buttons: “+ ” and “ - / °F/ °C”. The “+ ” button is used to increase setting values and the “ -/ ° F/° C” button is used to decrease setting values. To enter setup mode and begin the configuration process, press and hold the “ SET” button for about 3 seconds, or until the clock beeps. The display is now flashing “ 12 Hr” and you are ready to begin configuring your clock. 1. Set 12 or 24 Hour Time Mode With the display flashing “ 12 Hr”, press the “ +

Simply plug the adapter into the receptacle on the underneath of the alarm clock and then plug in adapter. 4. Replace the battery cover. 5. The projector will activate and remain on if the alarm clock is plugged in. If only batteries are used, the projector will only be activated when a button is pressed. The projection is a red light, not harmful under normal usage, although care should be taken to not look directly into the light. Notes: • After the batteries have been installed a tone will so

Large 7 inch Time display. . Large 3 .-inch calendar: Month, Date, Day . 12/24-hour time selectable . Atomic Time and Date with manual set option . Four Time Zones: Eastern, Central, Mountain, & Pacific . Daylight Saving automatically updates (On/Off option). . Time alarm with snooze IMPORTANT: - Do Not Mix Old and New Batteries - Do Not Mix Alkaline, Standard, or Rechargeable Batteries SETUP: . Lay the clock face down, on a clean soft towel or newspaper to prevent scratching. . Open the battery

. MINUTES: The minutes will flash. Press and release the PLUS button or the MINUS button to adjust the minutes. Press and release the MODE/SET button to confirm and continue to the next menu item. . SECONDS: The seconds will flash. Press and release the PLUS button or the MINUS button to adjust the seconds. Press and release the MODE/SET button to confirm and continue to the next menu item. . YEAR: The year will flash. Press and release the PLUS button or the MINUS button to adjust the year. Pre

. Time alarm with snooze IMPORTANT: - Do Not Mix Old and New Batteries - Do Not Mix Alkaline, Standard, or Rechargeable Batteries SETUP: . Lay the clock face down, on a clean soft towel or newspaper to prevent scratching. . Open the battery cover. Insert a finger in each of the indentations at the bottom of the battery cover. Push up then pull out to open the cover. . Insert three “C” alkaline batteries according to polarity markings. . Do not press buttons for four minutes to allow the clock to

S. La Crosse, WI 54601 Phone: 608.782.1610 Fax: 608.796.1020 For online contact / support / e-mail: lacrossetechnology.com/support For information on other products visit Page 7 of 8 All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher. This handbook may contain mistakes and printing errors. The information in this handbook is regularly ch