Login:
Sorted: Name ↓   Downloads   Rate   Size ↑  

Bard 357-93-E

downloaded: 17File size: 322 kb    Manafacture: Bard  
Category: Air Conditioner & Split Systems

compressor, electric heat strip and electrical controls) when two units are mounted side by side with minimal space between. The left side unit is the ideal product for telecommunication and over-the-road medical and communication vans requiring two wall-mount air conditioners be mounted side by side by using a WL (left side access) unit and a WA (right side access) unit on the same building. Factory or field installed accessories are also available to meet specific job requirements. Engineered

Bard CMH-3

downloaded: 10File size: 79 kb    Manafacture: Bard  
Category: Water and Air Pumps

The CMH-3 consists of: 1. Installation Instructions 7960-233A 2. Control Assembly 910-1095 3. Low Pressure Control 1804-0107 4. Unit Label 7961-312-0012 For use with all WH182 - WH602 Hi-Boy Wall Mount Heat Pumps. INSTALLATION INSTRUCTIONS Disconnect all power to unit. Remove control panel inner and outer covers, and right side condenser inlet grille. Circled numbers on Figure 2 correspond to installation instruction steps. Dashed lines indicate that a wire has been disconnected from this

Bard P1060A1

downloaded: 53File size: 500 kb    Manafacture: Bard  
Category: Air Conditioner & Split Systems

Table 6 shows minimum filter areas and recommended filter sizes. Actual filter sizes can vary with the installation due to single or multiple returns utilizing a filter/grille arrangement or being placed immediately ahead of the indoor coil face in the return air duct. TABLE 6 RECOMMENDED FILTERS Minimum Filter Recommended Model Areas Size P1142A3 608 square inches P1148A1 (2) 16 x20 x1 (4.62 square feet) P1060A1 NOTE: If roof hood accessory is to be used, information on air filters may be found

Bard P1142A3

downloaded: 15File size: 500 kb    Manafacture: Bard  
Category: Air Conditioner & Split Systems

50 .50 B18 --. 50 .50 C00 --. 50 .50 C09 --. 50 .50 C15 --. 50 .50 C18 --. 50 .50 Manual 2100-324 Page 4 Manual 2100-324 Page 5 FIGURE 1 PREFABRICATED ROOF CURB SPECIFICATIONS HEAVY GAUGE GALVANIZED WITH WOOD NAILING STRIP, WELDED/LEAKPROOF ONE PIECE CONSTRUCTION – READY TO INSTALL MIS-1177 FIGURE 2 FIELD FABRICATED CURBING MIS-1178 CURB AND ROOF DETAILS *Duct Sizing Information Return Air Dimension “C” is length Supply Air Dimension “C” is length Return Air Dimension “H” is width Supply Sir Dim

Bard P1148A1

downloaded: 12File size: 500 kb    Manafacture: Bard  
Category: Air Conditioner & Split Systems

IMPORTANT: While this electrical data is presented as a guide, it is important to electrically connect properly size fuses and conductor wires in accordance with the National Electrical Code and all existing local codes. Manual 2100-324 Page 3 GENERAL INSTRUCTIONS IMPORTANT The equipment covered in this manual is to be installed by trained, experienced service and installation technicians. All duct work, supply and return ducts, must be properly sized for the design air flow requirement of the e

Bard PH1224

downloaded: 0File size: 151 kb    Manafacture: Bard  
Category: Electric Heaters

A minimum of twelve inch elevation is recommended, while greater elevation may be required for areas of high snow accumulation. Poured concrete, steel framework, brick, cement block, etc., can be utilized to construct a suitable raised mounting platform. See Figure 6. DUCT WORK Refer to Tables 4, 5 and 5A when designing duct work for maximum static pressure available with the specific model and heater package being installed. Unit duct work is suitable for 0” clearance to combustible materials.

Bard PH1230

downloaded: 0File size: 151 kb    Manafacture: Bard  
Category: Electric Heaters

1 General Instructions ................................................. 3 Important ................................................................ 3 Shipping Damage .................................................... 3 General ................................................................ 3 Field-Installed Heater Packages (Optional) .............. 3 Installation................................................................. 5 Location .....................................................

Bard PH1236

downloaded: 0File size: 151 kb    Manafacture: Bard  
Category: Electric Heaters

(Also see “Electrical Data” on pages 2.) All models are suitable for connection with copper wire only. These instructions must be adhered to. Refer to the National Electrical Code for complete current carrying capacity data on the various insulation grades of wiring material. The electrical specifications on page 2 lists fuse and wire sizes (75° F copper) for all models including the most commonly used heater sizes. The unit rating plate lists a “Maximum Time Delay Fuse” or “HACR” type circuit b

Bard TCS22-***-003

downloaded: 0File size: 2 mb    Manafacture: Bard  
Category: Watches

III, Tab 19 Table Of Contents 1.0 INTRODUCTION ...........................................................................................................1 1.1 Shipping Damage .........................................................................................................................1 1.2 Package Contents .........................................................................................................................1 1.3 Additional Requirements .............................

Bard WA381

downloaded: 66File size: 312 kb    Manafacture: Bard  
Category: Air Conditioner & Split Systems

2 Shipping Damage .................................................... 5 General ................................................................ 5 Duct Work ................................................................ 6 Filters ................................................................ 6 Fresh Air Intake ....................................................... 6 Condensate Drain .................................................... 6 Installation Instructions Wall Mounting Information .





Category