No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions and replacement parts, please call 1-800-444-3353 Specifications Pump: 1/2 GPM Output Overall Dimensions: 18” x 13-1/2” x 9” Flexible Spot: 13-3/4” Motor: 110 Volt, Single Phase Shipping Weight: 18 lbs. Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating
. . ARGHERIT. Mode. A 112. Dimension. width 59,5 c. height 85 c. depth 53,5 c. Capacit. from 1 to 5,5 k. Electrica. connection. voltage 230/240 Volt 50 H. maximum absorbed power 1850 . Wate. connection. maximum pressure 1 MPa (10 bar. minimum pressure 0,05 MPa (0,5 bar. drum capacity 46 litr. Spinning spee. up to 1100 rp. Control program. in complianc. with IE. regulation 45. programme 2. temperature 60°C. carried out with 5,0 kg load. This appliance conforms with the following E.E.C. directives
Dispensing liquid detergent We recommend the use of a detergent dosing ball, as provided by your detergent manufacturer. Adding fabric conditioner Pour the recommended amount of fabric conditioner into the compartment. Do not exceed the maximum fill line. Maximum load size Divide your laundry according to: -the type of fabric/the symbol on the label. - the colours: separate coloured garments from whites. Empty all pockets and check for loose buttons. . Do not exceed the weight limits stated be
2 Installation Drainage connections A B A. Connect the drain hose, without kinking it, to a draining duct or a wall drain fixed at a height between 65 and 100cm from the floor. B. Alternatively, place it over the edge of a basin, sink or tub, fastening the hose supplied to the tap. The free end of the hose should not be under water. ! We advise against the use of hose extensions. In case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150cm in
-to run the draining cycle alone, set the knob to the relative symbol and press the START/RESET button. All programmes except for 1, 2, 4, 8, 9, 10 and Draining (Model A1200WD only) Rapid Cuts the duration of the wash cycle by 30%. This function is incompatible with the SUPER WASH function. 1, 2, 3, 6, 7. Reduced Spin Reduces the final spin speed to 1000rpm Reduces the final spin speed on cotton programmes. 1, 2, 3, 4 (Models A1600WD, A1400SWD and A1400WD only) Extra Rinse Adds one extra rinse c
Programme key: To consult a straightforward chart of the different programmes available. PROGRESS INDICATOR LEDs: To find out which cycle phase is under way. The corresponding LED for the cycle in progress is illuminated. DRYING knob: A1200 - To set the drying time A1400 - To set the drying time and single level auto dry. A1600 - To set the drying time and 3 level auto drying (see Starting and Programmes). FUNCTION buttons: To select the functions available (see Starting and Programmes). When a
- 89/336/CEE of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments. Washing machine description Control panel Programme key Detergent dispenser Detergent dispenser: To add detergent and fabric softener (see page 8). Programme key: To consult a straightforward chart of the different programmes available. Pull the grey tab outwards to open it. LEDs: To find out which wash cycle phase is under way. If the Delay Timer function has been set, the time left until the programme starts wi
! Read these instructions carefully: they contain vital information on installation, use and safety. Unpacking 1. Unpack the machine. 2. Check whether the washing machine has been damaged during transport. If this is the case, do not install it and contact your retailer. Remove the transit fixings IMPORTANT: Follow these instructions to remove the TWO transit fixings. Situated one either side of the rear panel, BOTH transit bolts MUST be removed before use. ! Failure to do so may cause damage to
The transit fixings were not removed correctly (see Installation). . The washer dryer is not level (see Installation). . The washer dryer is closed in, between furniture cabinets and the wall (see Installation). . The water inlet hose is not connected correctly (see Installation). . The detergent dispenser is obstructed, clean it (see Care and Maintenance). . The drain hose is not secured properly (see Installation). . The detergent is not suitable for machine washing (it should bear the definit