Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  

Whistler PRO-800W

downloaded: 2File size: 534 kb    Manafacture: Whistler  
Category: Battery

Frontage Rd. Bentonville, AR 72712 TEL (479) 273-6012 FAX (479) 273-2927 CUSTOMER RETURN CENTER 551 N. 13th St. Rogers, AR 72756 Customer Service Tel (800) 531-0004 Email: info@whistlergroup.com P/N 401515 © 2010 The Whistler Group, Inc. If you have questions the operation of this Whistler please call Customer Service: 1-800-531-0004 Hours: Monday - Friday 8:00 am - 5:00 pm CT Please keep the receipt in a safe place. You may register your product online at If the unit is returned without a dated

Whistler PRO-400W

downloaded: 0File size: 557 kb    Manafacture: Whistler  
Category: Battery

Do not restart the inverter until the source of the problem has been identified and corrected. • To avoid battery drain, always disconnect the inverter when not in use. • Do not expose the inverter to moisture. • Avoid placing the inverter near sources of heat or in direct sunlight. • When in use, make certain that the inverter is properly ventilated. • Do not use the inverter near flammable materials, fumes or gases. • Always operate the inverter in accordance with the instructions in this manu

Whistler PRO-3000W

downloaded: 2File size: 572 kb    Manafacture: Whistler  
Category: Battery

(500W divided by 10V = 50A). 3. Conclusion: The reserve power of the battery is sufficient to satisfy the continuous load demand placed on the inverter for a maximum of about one hour. (49.8 Ah divided by 50A = 1 hour). Note: • When the inverter will be operating equipment or appliances with high continuous load ratings for extended periods, it is not advisable to power the inverter with the same battery used to power your vehicle. If the car or truck battery is utilized for an extended period,

Whistler PRO-2500W

downloaded: 0File size: 572 kb    Manafacture: Whistler  
Category: Battery

Keep the unit and all cords clear of the steering wheel, gas, brake and clutch To maintain your inverter in proper working condition, note the following important safety precautions: • MOISTURE. Keep the inverter dry. Do not expose it to moisture. Do not operate the inverter if you, the inverter, the device being operated or any other surfaces that may come in contact with any power sources are wet. Water and many other liquids can conduct electricity which may lead to serious injury or death. •

Whistler PRO-200W

downloaded: 5File size: 557 kb    Manafacture: Whistler  
Category: Battery

Important Information on Battery Chargers Using your inverter with battery chargers for power tools, flashlights, video cameras and laptop computers may cause damage to the inverter or the charging unit. Check with the appliance manufacturer for compatibility with modified sine wave inverters if you’re unsure. Although we advise against it, if you attempt to use a charging unit, monitor the temperature of the charging unit for approximately 10 minutes. If the charging unit becomes unusually warm

Whistler PRO-2000W

downloaded: 0File size: 572 kb    Manafacture: Whistler  
Category: Battery

This power surge is referred to as the "starting load" or "peak load." (By comparison, as standard light bulbs do not require a large starting load.) Once the equipment or appliance has up, it settles down to a slower pace and requires far less electrical power to operate. This lower power requirement is referred to as the "continuous load." In order to ensure that the capacity of your Whistler inverter is sufficient to meet the required start up load, you must first determine the power consumpt

Whistler PRO-1600W

downloaded: 0File size: 572 kb    Manafacture: Whistler  
Category: Battery

Check Whistler’s online store for cable availability. Cable options: For model Pro-2500 at 10 foot length, a subsitute for the #0000 gauge can be using 2 sets of #0 gauge wires connected in parallel to the battery. 12 Making the Connection. 1. Make certain that the Power switch is in 2. Connect the cables to the power input at the rear of the inverter and tighten the screws to make a secure connection. (To make these connections, install the wire connectors flush with the metal backing plates an

Whistler PRO-1200W

downloaded: 0File size: 572 kb    Manafacture: Whistler  
Category: Battery

• While connecting the inverter to the power source, make certain that the inverter is well removed from any potential source of flammable fumes or gases. • In the event a continuous audible alarm or automatic shut off, turn the inverter OFF immediately. Do not restart the inverter until the source of the problem has been identified and corrected. 23 pro1200to3000w.4/30/2010 8:55 AM Page 27 TROUBLESHOOTING TROUBLESHOOTING PROBLEM: TV Interference Overload LED on Problem Solution Electrical inter

Whistler PRO-100W

downloaded: 1File size: 46 kb    Manafacture: Whistler  
Category: Battery

Whistler POWER INVERTERS PRO-3000W

downloaded: 5File size: 572 kb    Manafacture: Whistler  
Category: Battery

Also, ensure that the antenna cable is properly shielded and of good quality. 17 OPERATION OPERATION pro1200to3000w.4/30/2010 8:55 AM Page 21 2. Change the relative positions of the inverter, antenna cables and television power cord. 3. Isolate the television, its power cord and antenna cables from the 12 volt power source by running an extension cord from the inverter to the television set. 4. Coil the television power cord and the input cables running from the 12 volt power source to the inver





Category