Before troubleshooting, always recheck the operation pro- cedures per Section 3 of this manual. To isolate a malfunction, proceed as follows: 1. Clearly define the problem (or symptom) and when it occurs. 2. Locate the problem in the Troubleshooting table. 3. Review all possible causes. Then, one-at-a-time work through the list of corrections until the problem is solved. 4. Refer to the maintenance procedures in the Maintenance Section to safely and properly make the checkout and repair needed.

Simply put, combi-ovens use both moist heat and dry heat — either separately or in unison, depending upon the application — to cook many diff erent foods in a wide variety of ways. This inherent versatility means that a single piece of equipment can replace your need for a steamer, grill and convection oven. Several factors set Henny Penny’s SmartCombi™ apart as the premium combi-oven on the market. Th e most important is the development of our patented Advanced Steam Technology,™ a better metho

The panel will fall into your hand. See photo at left. 2. Remove the light bulb. 3. Replace the light bulb with a Westinghouse #60A19/35, 130 Volt bulb. If this bulb is not available, a standard 60 watt bulb will work until a long life bulb can be obtained. 4. Replace the glass panel. 2-6 103 Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS Model HCS-2 Model HCW-3 1006 2-7 Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS (Continued) Model HCW-5 2-8 1006 Model HCS-2/HCW-3/HCW-5/HCW-8

INTRODUCTION This section provides the installation instructions for the Henny Penny Heated Merchandiser. Installation of this unit should be performed only by a qualified service technician. Do not puncture the heated merchandiser with any objects such as drills or screws as component damage or electrical shock could result. 2-2. UNPACKING The Henny Penny Heated Merchandiser is tested, inspected and expertly packed to ensure arrival at its destination in the best possible condition. The unit ha

Use the UP and DOWN buttons under the middle display to change the setting. Initialize System (SP-12) After entering the access code (1,2,3), press the P button eleven times. “DO SYSTEM INIT” shows in the top display, and “---” show in the middle display. This feature resets the controls to factory preset parameters, if the controls were preprogrammed, or will zero out the times and temperature. Press and hold either the UP or DOWN button in the middle display. The controls will beep, and the di

- SCR-8 8 - 7 03605 BASKET - COATED - SCR-8 8 - 7 03473 BASKET - STD. - SCR-6 -6 7 03604 BASKET - COATED - SCR-6 -6 7 43804* SOLID BOTTOM BASKET ASSY. - SCR-6 -6 7 43805* SOLID BOTTOM BASKET ASSY. - SCR-8 8 - 7 43813* GRID - SOLID BASKET - SCR-6 -6 7 43815* GRID - SOLID BASKET - SCR-8 8 - 7 03504* BASKET-SCR8 COATED CHICKEN (W ALMART) 7 - 7 03503* BASKET-SCR8 UN-COATED CHICKEN (W ALMART) 7 - 7 03509* BASKET - SCR8 - BUTTERFL Y 8 - 7 03511* BASKET - SCR6 - BUTTERFL Y -6 8 03524 STIXSTAND SKEWER -

factory, Eaton, Ohio, or F.O.B. authorized distributor. To validate this warranty, the registration card for the appliance must be mailed to Henny Penny within ten (10) days after installation. REPLACEMENT PARTS: Any appliance replacement part, except lamps and fuses, which proves to be defective in material or workmanship within ninety (90) days from date of original installation will be repaired or replaced without charge F.O.B. factory, Eaton, Ohio, or F.O.B. authorized distributor. The warra

4-3 Section 5. TROUBLESHOOTING 5-1. Troubleshooting Guide ........................................................................................... 5-1 5-2. Error Codes and Warnings.................................................................................... 5-2 GLOSSARY ......................................................................................................................... G-1 Distributors List - Domestic and International i 303 Model HHC-990 SECTION 1. INTRODUCTION SE

OPERATING CONTROLS Item Description Function 1 Main Power Switch with Built- In Indicator Lights A three way rocker switch with a center off position. Pressing the left side of the rocker switch (COOK position) operates the fryer, and the amber light illuminates. No light is visible when the switch is in the OFF position. To filter, press the right side of the rocker switch (PUMP position) to operate the pump motor, and the red light illuminates. 2 Single Stage Thermostat An electromechanical de

INTRODUCTION SECTION 2. INSTALLATION This section provides the installation instructions for the Henny Penny HC-941 Holding Cabinet. NOTE Installation of this unit should be performed by a qualified service technician. WARNING ] Do not puncture the skin of the HC-941 Holding Cabinet with drills or screws as component damage or electrical shock could result. 2-2. UNPACKING ' The Henny Penny HC-941 Holding Cabinet has been tested, inspected, and expertly packed to insure arrival at its d