for Transmission Input Power Input Shunt (if available) Control Panel Line Fault output Relay (contacts closed to halt radio transmissions) Bell I Alarm output LED Status Indicators (Grn)(Red) AC DC ON / ON OFF / ON Indication AC input is on / DC output is on. Normal. AC input is off / DC output is from Battery only. Step down Transformer is defective or unplugged, or the AC outlet is off. Battery will eventually discharge. ON /OFF AC input is on / DC output is off. The auto-reset ove

• Tests 12 Volt Rechargeable Batteries. • Display Shows Battery Voltage and Mhos. • Warns if battery voltage is too low. • Replaceable test leads. • Includes padded carrying case. • Includes self-adhesive test data labels. ** • Lifetime Limited Warranty. Specifications • Operating Voltage: 10.0V - 14 Volts D.C. • Current Draw: 1.1 Amps Max., 0.0016 Ah for full test. • Battery Leads: ~12 Inches. • Size: 4.4” W x 3”H x 1.15”D w/o carrying case. ** To reorder a pack of 100 test data labels specify:

It consists of a metal enclosure and 12 Volt DC power supply/battery charger. It supplies 1 Amp continuous current and 2.5 Amps peak for the brief high current demands of the radio during transmission. The design of the enclosure allows quick and easy field mounting of the transceiver and antenna. FEATURES • Supplies 12 Volts D.C. Power for Transceiver • Current: 2.5A Peak, 1A Continuous • Heavy Duty Metal Enclosure INSTALLATION 1. Mount transceiver in top right corner by sliding antenna t

This siren draws less current than many competitive units and features the ability to produce two distinct sounds from a single input trigger. The ComboTrigger™ option allows controls which have a single alarm output and pulsing option to activate both the burglar and fire alarm sounds. The MilliMiser™ option allows the already low current draw of the ELK-45 to be reduced even lower. This is ideal for controls with limited alarm output power. The ELK-45’s removable "U” shaped mounting bracket ma

Ready, Trouble, Armed, Stay, and Exit LEDs are lighting in a clockwize rotation. Keypad is communicating but it has not been enrolled with the Control. Use the bus module enrollment procedure to enroll the keypad into the Control. Numeric keys All Flashing Keypad is in the Setup Mode is waiting for an address setting. Refer to the instructions for address setting OR press the Exit key to return to regular operation. Erratic operation. LEDs and buttons do not seem to be responding properly. Impro

(IT IS NOT NECESSARY TO REMOVE THE SPEAKER.) © IF THIS IS A NEW SIREN BOX INSTALLATION, MOUNT THE STAINLESS STEEL BACKPLATE AND SPEAKER/SIREN ACCORDING TO INSTRUCTIONS PROVIDED WITH THAT UNIT. B) HANG THE STROBE UNIT ON THE LOWER FLANGE OF THE BACKPLATE BY SLIDING THE CLEAR PLASTIC WIRING PROTECTOR INTO THE LEFT (OUTER) SLOT OF THE BACKPLATE’S LOWER FLANGE. NOTE THAT THE END WITH THE LOOSE WIRES IS TOWARD YOU AND “UP”. INSURE THAT THE WIRE SLIDE HAS MOVED ALL THE WAY BACK TO THE WALL. C) CON

It installs between the RJ31X Phone Jack and the Security Control. The ELK-952 features multi-stage protection and is 5 times faster than MOVs. • 5 Stage Surge Protection • Very Economical • Easy to Install • Works with Any Security Control INSTALLATION INSTRUCTIONS This device installs in-line between the RJ31X Phone Jack and the Security Control. It features multi-stage protection: (Tip-Ring, Tip-Ground, Ring-Ground) utilizing Gas Discharge Tube, Spark Gaps, Clamping Diodes, and series i