3824 North 5th St., Suite C, North Las Vegas, NV 89032 Contents Introduction ................................................................................................... 3 Quick Tour ...................................................................................................... 5 How to program a timed event .................................................................. 6 Special programming buttons ................................................................... 6 Setting u

range. The FireCracker Computer Interface sends Wireless Radio Frequency (RF) signals from your PC to an X10 Transceiver (TM751 included). The Transceiver then passes the signals onto your house wiring to control lights or appliances around your home. You plug lights and appliances into X10 Modules (sold separately). 1. Set the TM751 Transceiver to Housecode A. Plug a lamp or appliance into the TM751. Plug the TM751 into an AC outlet (use one near your PC for now). 2. 3. 4. 5. 6. Plug t

400 Forge Way, Suite 409-412, Model Airpad 1 Rockaway, NJ 07866 CM002-11/11 ContentsRead First ContentsRead First FCC Caution THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital dev

DO NOT plug the VA13A USB adapter into your PC until you install the X10 software. 1. Download the desired X10 software/drivers from: 2. Run the installation program. Select the directory where the software will be installed, and follow the on screen instructions. 3. When the installation program instructs you to plug in the USB adapter, plug the VA13A into your USB port. Your computer will recognize that new hardware has been connected and will complete the installation. 4. Plug an XCam camera

Using Wi-Fi Setting the Date and Time, cont. Using Wi-Fi 3. Uncheck Automatic (to manually set) and then touch Set time. 4. Set the correct time and touch Set. 5. Touch Select time zone. Scroll and select your time 6. Touch Set date. Select the correct date and touch 7. Similarly, set other options such as time and date format. 8. Touch the Home icon or hard key to the right of the screen to exit back to your Home screen. You can also repeatedly touch icon or hard key. 8 In order to connect to t

These basic procedures work for other Apps too. 1. On your Home screen, touch (top right of the screen). 2. Touch the Amazon Appstore icon. The screen shown at the bottom of page 11 is displayed. 3. In the Search Market box, type: kindle for. As you type, various matches will be displayed. When you see kindle for android tablet displayed, touch it. 4. Touch the Kindle for Android icon. 5. Touch Install. Then touch OK. When “Application installed” is displayed, click Done. Touch the Home icon (bo

Charge the monitor for a few hours before attempting to use it without the power supply, (it can take 7 to 10 hours to fully charge the battery the first time, and around 4 hours thereafter). At any time you can “back out” from where you are by pressing the Monitoring button. If the screen times out and turns off while you’re following the steps below you can wake it up by pressing any button. First you’ll need to “match the units”: Press the power button on the left side of the Monitor (the

LIMITED 1-YEAR WARRANTY X10 (USA) Inc. warrants X10 products to be free from defective material and workmanship for a period of one (1) year from the original date ofpurchase at retail. X10 (USA) Inc. agrees to repair or replace, at it’s sole discretion, a defective X10 product if returned to X10 (USA) Inc. within the warranty period and with proof of purchase. If service is required under this warranty: 1. Call 1-800-675-3044 or e-mail sales@x10.com for details on how to return your unit(s).