Adjust the [TRIM] control appropriately so that the [PEAK] indicator is lit at the loudest part of playing.
2. Mix the signals recorded on tracks 1 through 6 and record the mixed signal onto tracks 7 and 8. Then tracks 1 through 6 can be used to record other materials. This is the basic technique used for Multitrackers. We recommend that tracks 7 and 8 are basically used as the destination tracks of “track bounce” from tracks 1 through 6. See “Advanced Operation” for details about the track bounce technique. In addition, tracks 7 and 8 play an important role in “training mode” and “mastering mode” des
A separate document (Order No. 8288010101) is available for the revised section of the manual. * The Service Manual for A-8LR starts from page 71 . 8 TRACK RECORDER/REPRODUCER Service Manual UK and AUS versions FCA and CND versions EUR versions DM versions 0700464 ^ 0201667 ^ 0601195 ^ 1000632 ^ Fostex TABLE OF CONTENTS 1. INTRODUCTION ................................................ 3 2. SPECIFICATIONS................................................ 4 3. THE CONTROLS AND THIER FUNCT
[INPUT SEL] Key * Set whether to send the A to H input signals [INPUT] or track 9-16 play [TRACK] sounds to the faders of channel faders 9 to 16. 26. [REC ASSIGN-BUSS-SOURCE] Key * Select the channel (SOURCE) to send to the REC BUSS during “BUSS” recording. Select the SOURCE channel with the [CH STATUS/CH SEL] key. * This key lights ON when the SOURCE is selected. 27. [REC ASSIGN-BUSS-REC TRK] Key * The track (READY) to record in “BUSS” recording is selectable when this key is flashing. Set READ
DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Tne iighinng flash with arrownead symbol, within an equilateral triangle, is intended to alori the user to the presence of uninsulated "dangerous voltage" within me product's enclosure lhat may be of sufficient magnitude to constitute a risk ot electric shock to persons The exclamation pont withm an eauiiatera: triangle is intended to alert the user to the oresonce ot important op
DO NOT EXPOSE THIS APPLIANCE TO RAN OR MOISTURE.'' SAFETY INSTRUCTIONS Read Instructions - All the safety and operating inductions should be read before ihe appliance is operated. Retain instructions - The safety and operating instructions should be retained Icr future reference. Heed Warnings —All warnings on tlx; applianceand in the operating instructions should be adhered 10. Follow Instructions - All operating and use instructions should be followed. Water and Moisture - The appliance s
Recording a SKIP-ID at the Desired Point The undesired section can be skipped. During playback, a SKIP-ID can be recorded at the desired point. CM and narration can be skipped. The SKIP-ID is recorded at the start of the section to be skipped. When a SKIP-ID is found during playback, the D-5 will skip to the next S-ID. 1. Press the ID MODE button and select "WRITE-SKIP." ID MODE START WRITE ► SKIP END 2. Press the PLAY button. Playback from slightly before where SKIP-ID is to be reco
3.2. CAUTION: Do not place anything on the hatched section as doing so will decrease heat sink efficiency. 3.3 Console mount The B-16 can be used at any free angle by using the Model 9080 as shown in Fig. 3.3 (option). 3.4 Remote control unit Model 8090 The multi-cable from the Remote Control Unit is plugged into the REMOTE CONTROL jack (25) on the B-16 rear panel. The Remote Control Unit can also be used on a mic stand by utilizing the bracket as shown in Fig. 3.4. 3.5 Line Amplifier Mod