160TH ST., CLEVELAND, OHIO 44135 E.-U. • 800-251-0001 Mr. Heater et HeatStar sont des marques de commerce deposees de enerco Group, Inc. © 2003, enerco Group Inc. Tous droits reserves. ENERCO GROUP, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 • 800-251-0001 08/08 #50120 4000ID Serie Chauffage Portatif Indirect-tire NO. STOCk NO. DESCRIPTION 67 e30443 Cable avec fiche et presse cable 68 e11030 Lampe 230V 69 T20353 Gicleur 1,50 GPH 45° W 70 P10137 Tete broleur avec electrodes 71 e10254 electrod

2. Mark screw locations on wall (see figure 7). 3. Remove tape and mount bracket from wall. Figure 7 Attaching to Wall Stud: For attaching mounting bracket to wall studs 1. Drill holes at marked locations using 9/64” drill bit. 2. Place mounting bracket onto wall. Line up holes on each end of bracket with hole drilled in wall. 3. Insert mounting screws through bracket and into wall studs. 4. Tighten screws until mounting bracket is firmly fastened to wall studs. Attaching to Wall using Anchor: F

to 14” W.C. Pressure) 1/8” NPT Plug Tap Tee Joint Sediment Pipe Nipple Trap Cap 3” Minimum Figure 12 *A CSA/AGA certified equipment shutoff valve with 1/8” NPT tap is an acceptable alternative to test gauge connection. Purchase the CSA/AGA certified equipment shutoff valve from your dealer. IMPORTANT: Install an equipment shutoff valve in an accessible location. The equipment shutoff valve is for turning on or shutting off the gas to the appliance. Apply pipe joint sealant lightly to male thread

Do not allow anyone who has not read these instructions to assemble, light, adjust or operate the heater. GAS-FIRED INFRA-RED PORTABLE HEATER CYLINDER NOT INCLUDED MODEL MH12CS MODEL MH12C If the information in this manual is not followed exactly, a fire or explo- sion may result causing property damage, personal injury or loss of life. WARNING: — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. — An LP cylinder not connected for

Cylinder 20 Lb. Cylinder 1 1 1 2 2 2 Hi Med Lo Hi Med Lo 14,000 2,000 8,000 28,000 24,000 16,000 17 20 28 9 10 15 30 35 52 15 18 28 Figure 2 Mr. Heater | Gas-Fired Infra-Red Portable Heater 4 Operating Instructions and Owner’s Manual 2. 2. A. READ INSTRUCTIONS CAREFULLY: Read and adhere to these instructions. Do not allow anyone who has not read the instructions to assemble, light, adjust or operate the heater. WARNING KEEP THE HEATER OUT OF THE REACH OF CHILDREN B. PROPANE IS VERY FLAMMABLE: In

These include attics* and crawl spaces. Follow the National Fuel Gas Code NFPA 54/ ANSI Z223.1, Section 5.3, Air for Combustion and Ventilation for required size of ventilation grills or ducts. *IMPORTANT: Do not provide openings for inlet or outlet into attic. If attic has a thermostat-controlled power vent, heated air entering the attic will activate the power vent. IMPORTANT: Vent-free heaters add moisture to the air. Although this is beneficial, installing heater in rooms without enough vent

MANUAL MAIN SHUT-OFF VALVE (FURNISHED BY INSTALLER) GROUNDED JOINT UNION WARNING Danger of explosion. Can cause injury or product or property damage. If over- heating occurs or if gas supply fails to shut off, shut off the manual gas valve to the appliance before shutting off electrical supply. 1/8 NPT PLUGGED TAP GAS FLOW DRIP LEG FIGURE 8 WARNING GAS SUPPLY TO UNIT HEATER Electric shock hazard. Can cause injury or death. Before attempting to perform any service or maintenance, turn the electri

FOLLOW SHUTDOWN AND STORAGE INSTRUCTIONS TO TRANSPORT OR MOVE THIS APPLIANCE. Mr. Heater | Gas-Fired Infra-Red Portable Heater 4 Operating Instructions and Owner’s Manual 3. 3. A. WARNING: This heater is an unvented appliance and MUST be used ONLY in a well ventilated area. NEVER attempt to operate the heater inside any vehicle, camper or enclosure. B. Any combustion process requires and consumes oxygen, and will produce carbon monoxide. THIS HEATER MUST BE USED WITH ADEQUTATE VENTILATION. Do no

6. Push in control knob and rotate control knob back to OFF position then rotate counterclockwise to PILOT/IGN position. This will light pilot. If needed gently keep rotating control knob WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life. A. This appliance has a pilot that must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the app

5. When specified, in contaminated environments, the burner shall be capable of supplying outside air to each burner for the support of combustion. 6. All burners shall be pre-wired with a grounded electrical cord and plug. 7. At customer’s choice, burners may be controlled with either an optional line voltage thermostat or by optional low voltage thermostats with an appropriate low voltage transformer relay. 8. Gas supply to the burners shall conform to the following: 1/2” NPT gas connector siz