Es gibt aber auch symmetrische dynamische Mikrofontypen, die besonders empfindlich sind und eventuell durch die Phantomspannung beschadigt werden konnten. Entnehmen Sie bitte nahere Informationen den Bedienungsanleitungen der von Ihnen verwendeten Mikrofone. Sicherheitshalber sollten Sie stets darauf achten, da. die PHANTOM POWER ausgeschaltet ist , wenn symmetrische dynamische Mikrofone an die Mikrofoneingangsbuchsen angeschlossen werden. Sie vermeiden damit eine mogliche Beschadigung dieser be
38. AUX3/4 POST As already previously described, this switch allows determining whether Pre- or Post-Fader signals are present at the AUX3/4 channel. The corresponding yellow LED signals when the switch is engaged and all input channel AUX3/4 controls are assigned post fader. 39. FEEDBACK FILTER The feedback filter is a very narrow banded notch filter, which is only active in a range that is extremely susceptible for acoustical feedback. The FEEDBACK filter rotary control sets the corresponding
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Scope of Delivery, Unpacking and Inspection . . . 5 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Installation and Connections . . . . . . . . . . . . . . . . 5 CONTROLS, INDICATORS AND CONNECTIONS . . . . . . . . . . . 8 Input Mono . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Input Stereo . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 FX1/2 . . . . . . . . . . . . . . . .
27 - SIG/PK The stereo SIG/PK indicator function provides independent analysis of left and right channel audio signals. The respective highest level reading is indicated, assuring that neither one is already driven into clipping. For further information on how to use this indicator most efficiently, please refer to the description of the monaural channel’s identical feature. 28 - FADER The channel fader is used to simultaneously adjust both levels (volumes) of the stereo signal. Functioning and
Select Omni if commands from all channels should be accepted. Select Off if the effect unit should not be controlled via MIDI. Select the setting 0 -127 if using MIDI devices that start counting program change commands from 0. Select the setting 1 -128 if using MIDI devices that start counting program change commands from 1. Table 3-16: FX Control Setup parameter DEVICE SETUP This dialog can be used for editing system parameters and checking system properties. Some menu entries (e.g. Display Bri
A huge number of additional filters offers extremely flexible correction of the frequency response. Each input incorporates a 5-band equalizer, allowing to assign high and low-pass, high and low-shelving or parametric peak-dip filters to its individual filter sections. Next to the frequency crossover filters, four additional filters are employed in each output channel, which also can be set to work as high or low-pass, high or low-shelving filters, parametric peak-dip filters, or all-pass filter
The two 18-Bit digital processors offer a total of 198 high-quality effect combinations in well-known Dynacord-quality, but employing new 32-Bit algorithms. Pre Outs • Master A and B, Mono, subwoofer out with low-pass-filter, record send control • perfect headphones control via PFL/PGM/Mix (with specific 20 mm transition-fader Power Amplifier • 2 x 300 watts/4 Q • LpN-processor • Up to three 8 Q loudspeakers on a single channel • 7-Band graphic Master-EQ • Power Amp In Case • Lightweight (on
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacture’s instructions. 8. Do not i
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Input/Mono . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Input/Stereo. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Effekt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To learn more about every aspect of the software, please read the following parts of this manual carefully. 7.4.2 Menus And The Toolbar File Menu -Create a new file -Open an already existing file -Save a file -Save an already existing file under a new name -Print all parameters of the momentarily opened file -Preview of the page to print -Printer settings -Open the last modified file -Quit the program 7-2 SOFTWARE EDITOR DRM 4000 View Menu -Change the status of the symbol bar - visible / invisib