Failure to follow these instructions could result in property damage, bodily injury, or even death. A Contact your local building or fire officials about restrictions and installation inspection requirements in your area. A Save these instructions. jJjJj UNITED STATES STOVE COMPANY • 227 INDUSTRIAL PARK ROAD • SOUTH PITTSBURG, TENNESSEE 37380 • WWW.USSTOVE.COM FOR TECHNICAL ASSISTANCE: PHONE: (800) 750-2723 FAX: (423) 837-2109 Part No.: 851655B Table of Contents TABLE OF CONTENTS.........

IS SUGGESTED FOR PROPER BURNING OF THIS UNIT WHEN USING WOOD. CHIMNEY MAINTENANCE Creosote and Soot - Formation and Need for Removal When wood is burned slowly, it produces tar and other organic vapors, which combine with expelled moisture to form creosote. The creosote vapors condense in the relatively cool chimney flue of a slow-burning fire. As a result, creosote residue accumulates on the flue lining. When ignited, this creosote makes an extremely hot fire. The chimney should be inspected at

See the appropriate sections of this manual for instructions. 8. WARNING: Do not allow fans to blow directly into the fireplace. Avoid any drafts that alter burner flame patterns. Do not place a blower inside burn area of firebox. Ceiling fans may create drafts that alter burner flame patterns. Sooting and improper burning will occur. This is an vent-free gas-fired heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be

• Do not install a flue damper in the exhaust vent of this unit. • Termination must exhaust above air inlet elevation. Installation MUST include three (3) vertical feet of pellet vent pipe. This will create some natural draft to prevent the possibility of smoke or odor during appliance shutdown and to keep exhaust from causing a nuisance or hazard from exposing people or shrubs to high temperatures. Do not connect this unit to a chimney flue serving another appliance. Do not connect directly to

2. Pull the slide baffle rod to the front position. 3. Open the fuel load door and light fire using kindling and several sheets of newspaper, then close the furnace door. The furnace door should remain closed for 5 to 10 minutes in order to establish the fire. If the fire has established, you are ready to load the furnace. CAUTION: To prevent flame and smoke spillage, the slide baffle must be pulled out and the fuel door must be cracked for ten seconds before being fully opened. Do not over fire

INSTALLATION #2 Extending the hot air duct from the furnace into the existing plenum will help direct the flow of air from the furnace as well as the flow in the existing furnace. Ducting entering the existing plenum at an angle (approximately 45 degrees) will facilitate air flow from the furnace while diverting air from the existing furnace. (Optional) Back Draft Damper Furnace Existing Furnace INSTALLATION #3 The baffle on this system should be made the full width of the furnace plenum in orde

FOR PURPOSES OF THE TAX CREDIT, BOTH OF THESE STOVES EXCEED THE 75% MANDATE, AS THE TEST CRITERIA WAS BASED SOLELY ON THE “LOWER HEAT VALUE,” RATHER THAN THE ABOVE SCALE. THIS MODEL MEETS ALL REQUIREMENTS FOR TAX CREDIT. Before installing your stove Adequate Provision of Air Specifications Model Maximum Output Overall Efficiency (%) Size H x W x D Flue Size Net Weight 3500 3500PB 37,000BTU or 11KW 73 26.” x 20.” x 16.” 675mm x 530mm x 420mm 6" 150mm 306 lb (139 kg) 3700 3700PB 63,000BTU or 18.5K

. . MODEL: 1600GC / 1800GC MODEL: 1600GC / 1800GCMODEL: 1600GC / 1800GCMODEL: 1600GC / 1800GCMODEL: 1600GC / 1800GCMODEL: 1600GC / 1800GC CANADA CANADACANADACANADACANADACANADA ONLY ONLYONLYONLYONLYONLY . . . . . SAFETY NOTICE: SAFETY NOTICE:SAFETY NOTICE:SAFETY NOTICE:SAFETY NOTICE:SAFETY NOTICE: IF THIS FURNACE IS NOT PROPERLY INSTALLED, A HOUSE FIRE IF THIS FURNACE IS NOT PROPERLY INSTALLED, A HOUSE FIREIF THIS FURNACE IS NOT PROPERLY INSTALLED, A HOUSE FIREIF THIS FURNACE IS NOT PROPERL

When writing, always give the full model number which is on the nameplate attached to the inside of the cabinet door of the heater. When ordering repair parts or options, always give the following information as shown in this list: 1. The PART NUMBER 2. The PART DESCRIPTION 3. The MODEL NUMBER: 2941 4. The SERIAL NUMBER:________________ Before installing your heater, fill in the serial number of your heater in the space provided above. OWNERS MANUAL Model 2941 WONDERWOOD THERMOSTAT CONTROLLED WO