Votes - 4, Average rating: 4.8 ( )

Manafacture: Enerco File size: 1.52 mb File name: Language of manual:

6. Push in control knob and rotate control knob back to OFF position then rotate counterclockwise to PILOT/IGN position. This will light pilot. If needed gently keep rotating control knob WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life. A. This appliance has a pilot that must be lighted by hand. When lighting the pilot, follow these instructions exactly. B. BEFORE LIGHTING smell all around the appli- ance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call you gas supplier from a neigh- bor’s phone. Follow the gas supplier’s instruc- tions. • If you can not reach your gas supplier, call the fire department. • Use only your hand to push in or turn the gas control knob. Never use tools. If knob will not push in or turn by hand, don’t try to repair it; call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion. • Do not use this appliance if any part has been underwater. Immediately call a qualified service technician to inspect the appliance and to re- place any part of the control system which has been underwater. LIGHTING INSTRUCTIONS 1. STOP! Read the all safety information included with and on the side of heater. 2. Check that gas supply to heater is on. 3. Push in gas control knob and slightly turn clock- wise to the OFF position (see figure 16). Note: Knob cannot be turned from PILOT to OFF unless knob is pushed in slightly. Do not force. 4. Wait five (5) minutes. Then smell for gas, in- cluding near the floor. If you smell gas, STOP! back and forth while depressed until pilot lights. 7. Keep control knob depressed in for ten (10) seconds after lighting pilot. If pilot goes out, repeat steps 4, 5, 6 and 7. If pilot does not stay lit, refer to Troubleshoot- ing, pages 12-13. Also, contact a qualified service person or gas supplier for repairs. If control knob does not pop up when released, contact a qualified service person or gas sup- plier for repairs. 8. FOR IR10LP: Turn control knob to “LO” to light heater. Leave on “LO” position until the left burner tile has turned bright orange. After left burner tile has turned bright orange, adjust heat output by turning Control Knob to desired position (“LO” or “HI”). Note: Both tiles turn orange only on HI setting. FOR BF10LP: When the pilot is lit, turn the control knob to “HI” position to light. FOR BF10LP: After flame is established on “HI”, adjust heat output by turning control knob to de- sired position (“LO” or “HI”). Do not operate heater between locked positions. Figure 16 CAUTION: Do not try to adjust heating level by using equipment shutoff valve. WARNING: When running heater, set control knob at “L...

Download now

Please, enter two numbers from picture: