Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
What is New in This Version
This version of the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver contains only defect fixes
and does not offer any new feature. For information about the defect fixes, see “Defects Fixed in
This Release” (page 8).
Installation Requirements
You must install the following software and patch before installing the HP PCI Tachyon TL/TS/XL2
Fibre Channel driver on the system:
•
Fibre Channel Mass Storage (FCMS) Patch PHKL_23626 or later
This patch is available for download at the following websites:
http://h20293.www2.hp.com/
http://itresourcecenter.hp.com
Verifying the HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver Installation
To verify whether the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver is installed successfully
on your system, enter the following command at the HP-UX prompt:
# swlist FibrChanl-00
Where:
FibrChanl-00
is the bundle name for the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver.
If the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver is installed successfully on the system,
the following message is displayed:
# Initializing...
# Contacting target "hostname"...
#
# Target: hostname:/
#
# FibrChanl-00 B.11.11.17 PCI/HSC FibreChannel;Supptd HW=A6684A,A6685A,A5158A,A6795A
FibrChanl-00.FC-TACHYON-TL B.11.11.17 PCI/HSC FibreChannel;Supptd HW=A6684A,A6685A,A5158A,A6795A
Known Problems and Workarounds
Following are the known problems and workarounds in the HP PCI Tachyon TL/TS/XL2 Fibre
Channel driver:
•
Problem: During online replacement (OLR) of the A6795A adapter in Superdome systems,
the replacement can fail if the adapter is connected to the hub, switch, or device, and the
following error message is displayed:
OLARD error: General error
The slot is inaccessible till you power cycle the system.
Workaround: Disconnect the cable from the adapter before you perform online addition
and replacement (OLAR) operations.
•
Problem: During online replacement (OLR) of the A6795A adapter on L3000 systems, the
replacement can cause a system panic (high-priority machine check (HPMC)) if the adapter
is connected to the hub, switch, or device. The subsequent boot hangs unless you power
cycle the system.
Workaround: Disconnect the cable from the adapter before you perform the OLAR operations.
•
Problem: During online replacement (OLR) of the A6795A adapter on the L2000 system,
the replacement may fail and the following error message may be displayed:
OLARD error: General error
Workaround: This problem is fixed in Processor Dependent Code (PDC) Version 41.38.
What is New in This Version
7
...Other models in this manual:
Network Equipment - HP-UX 11i v1 I/O Cards (194.15 kb)