Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
1.
To view the Emulex driver handle information, type Shell> drivers at the EFI shell
prompt - - a list of drivers is displayed.
2.
Write down the driver handle associated with the Emulex SCSI Pass Thru Driver. The first
column, labelled DRV, lists the driver handles.
3.
Enter the drvcfg -s
is 20 (your driver handle may be different): Shell> drvcfg -s 20. Information is
displayed, listing all of the HBAs in your system; your listing may vary, depending upon
how many HBAs are installed in your system.
4.
Using the arrow keys, locate the HBA that you want to configure, select (i.e., highlight)
the corresponding row, and press Enter.
5.
Select (highlight) the Setup Utility option and press Enter.
6.
Select (highlight) the Configure HBA Parameters option and press Enter.
7.
Select (highlight) the Force Link Speed option and press Enter.
8.
Select (highlight) the 2Gb/s link speed option from the list presented, and press Enter.
9.
After completing your selection, use the ESC key to exit the EFI configuration menus.
•
Using ioscan with krm not running
When ioscan is run with the —fn or —Fn option, and the kernel resource monitor (krm) is
not running, there could be stale krm device files in the system, which would correspond to
different devices, including fclp, in ioscan output. This issue has no impact on the functionality
of the Fibre Channel port; however, ioscan output may be confusing. This issue can impact
any card accessible with ioscan, and is not specific to the cards supported by the fclp driver.
Corrective Action:The ioscan output can be returned to normal by either deleting the stale
krm device files, or by starting krm, which will recreate the device files.
Compatibility and installation requirements
This section describes the compatibility information and installation requirements for this release.
For specific installation instructions, refer to the installation guide specific to your FibreChannel
card.
NOTE:
FibrChanl-02 on HP-UX 11i v3 is supported with VxVM 5.0 or later, including boot and
Ignite/UX.
Operating system and version compatibility
The following software (or later versions) must be installed before installing the FibrChanl-02 (fclp)
driver, version B.11.31.1303, into a system:
•
HP-UX 11i v3 OS Fusion version B.11.31.1103 or later
•
HP-UX CommonIO B.11.31.0803 or later
•
HP-UX 11.31 Support Tools Bundle, March 2008 (OnlineDiag), version B.11.31.03.06
NOTE:
The FC-COMMON.FC-SNIA fileset is part of the CommonIO bundle. If
FC-COMMON.FC-SNIA (0803 or later) is not present on a system, swinstall of theFC-FCLP
product will display errors. If you ignore the errors and proceed with the swinstall, the
FC-FCLP.FC-FCLP-RUN fileset will not be installed.
This patch is required only if your system is missing the March 2008 HP-UX 11.31 Support Tools
Bundle:
•
PHSS_37101 (scsi_arry patch)
Driver bundles can be downloaded from the HP Software Depot at: http://www.software.hp.com
Patches are available from either: http://www.software.hp.com or http://itresourcecenter.hp.com
Compatibility and installation requirements
9
...
Network Equipment - HP-UX 11i v3 I/O Cards (353.05 kb)