Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
1.
Attach loop back hoods to all of the unconnected HBA ports. The loop back hoods will
cause the unconnected HBA ports to come online in a private loop topology.
2.
Install the product bundle, mtIOScan, that enables boot time kernel threads. This will
reduce the overall boot delay due to unconnected ports to 21 seconds. This product can
be obtained from www.software.hp.com
•
swlist Does Not Indicate the Mezzanine HBAs
swlist does not indicate the Mezzanine HBAs, and cannot be added onto because of string
size limitation.
Corrective Action: Refer to Hardware Requirements later in this document for more information.
Compatibility and Installation Requirements
This section describes the compatibility information and installation requirements for this release.
For specific installation instructions, refer to the installation guide specific to your FibreChannel
card.
Operating System and Version Compatibility
The following software (or later versions) must be installed before installing the FibrChanl-01 (fcd)
driver, version B.11.23.1003.01 into a system:
•
FibrChanl-00 (td) version B.11.23.03 or later (for HP-UX 11i v2 Update 3)
•
Product number B6191AAE, OnlineDiag bundle version B.11.23.03.xx, release in September
2004 (HWE0409)
•
PHKL_33827 patch or later for HP-UX 11i v2 (needed for fcmsutil (1M) support for options
set_int_delay and get_int_delay)
•
PHKL_36143 patch (needed for fcmsutil (1M) support for option sfp supported by 4Gb
Fibre Channel HBAs)
•
PHKL_31500 patch or later (needed for HP-UX 11i v2)
•
PHKL_31226 patch (only needed if OLAR functionality is required; applies to all cards that
have a bridge, including A9782A, A9784A, and AB465A)
•
PHKL_34851 (needed for HP-UX 11i v2)
Driver bundles can be downloaded from the HP Software Depot at: http://www.software.hp.com
Patches are available from either: http://www.software.hp.com or http://itresourcecenter.hp.com
OnlineDiag is available at http://www.software.hp.com in the Enhancement releases and patch
bundles section, or on the HP-UX 11i v2 OE media (September 2004 and later). Installation
instructions are available at: http://docs.hp.com/hpux/onlinedocs/diag/st/st_inst.htm
Requirements for Boot Support: AD193A/AD194A, 403619–B21, AD300A, AB378A, AB378B,
AB379A, AB379B, A6826A, A9782A, A9784A, AB465A
To boot through the fibre channel ports on these adapters, HP recommends that you update the
EFI driver and onboard firmware to the latest version. The following table lists the recommended
EFI and firmware versions at the release of FibrChanl-01 (fcd) driver, version B.11.23.1003.01
or later:
Table 20 Recommended Firmware Versions (March 2010 or later)
Fibre Channel Adapter
EFI Driver Version
Firmware Version
AD193A/AD194A
1.05 or later
4.00.70 or later
403619–B21
1.09 or later
4.00.90 or later
AD300A
1.05 or later
4.00.70 or later
Compatibility and Installation Requirements
11
...Other models in this manual:
Network Equipment - HP-UX 11i v2 I/O Cards (208.44 kb)