Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
Desktops - HP Integrity NonStop H-Series (1.98 mb)
Desktops - HP Integrity NonStop H-Series (16.73 mb)
Desktops - HP Integrity NonStop H-Series (957.56 kb)
Desktops - HP Integrity NonStop H-Series (2.38 mb)
Desktops - HP Integrity NonStop H-Series (881.66 kb)
Desktops - HP Integrity NonStop H-Series (965.62 kb)
Desktops - HP Integrity NonStop H-Series (676.93 kb)
Desktops - HP Integrity NonStop H-Series (393.72 kb)
Desktops - HP Integrity NonStop H-Series (776.57 kb)
manual abstract
Troubleshooting
Fault Symptom Codes (FSCs)
Table 6-2. Fault Symptom Codes
Message
FSC ERP
Unknown
701E
C, G
Attempt to show detailed drive status of a
drive whose type is unknown.
The SCSI response
701F
C, G
The command response from the SCSI
was not expected
task in a remote module was unexpected.
The Flash response
7020
C, G
The command response from the Flash
was not expected
task in a remote module was unexpected.
SCSI response not
7021
C, G
A command response was received from
matched to a known
a SCSI task, but the original command
command
opcode could not be determined.
Unexpected state after
7022
C, G
After successfully completing a
NonVolConfig cmd
NonVolCofigPut command, the current
state of the save operation was unknown
Unexpected state after
7023
C, G
After successfully completing a
SCSI mode cmd
SCSIUpdateModeParameters command,
the current state of the save operation
was unknown.
Unexpected state after
7024
C, G
After successfully completing a
SCSI init cmd
SCSIInitcommand, the current state of the
save operation was unknown.
Cartridge reject
8001
C, D, G
The DLT drive failed to successfully load
recovery failed
a tape even after retries.
Drive Fan stalled
8002
C, D, G
The fan in the drive hot-swap shoe is
either not installed or has stalled.
Drive load did not
8003
C, D, G
The drive failed to successfully load a
complete
tape.
Invalid drive was
8004
F
One or more installed drives are of a type
installed
either unknown or not supported in the
current ACL personality.
LTO unmask drive
8005
F
The LTO drive unmask operation failed.
failed
LTO mask drive failed
8006
F
The LTO drive mask operation failed.
LTO unload drive (In
8007
F
The LTO drive failed to unload a cartridge
load retry) failed
during a load retry operation.
Is Drive Unloaded
8008
F
The LTO drive failed to return status when
Failed
being polled for unloaded state.
Orphan cartridge
9001
C, D, G
The master module could not successfully
recovery failed
return an orphan cartridge to a slot
location.
Master pass-thru opto
9003
C, D, G
The master module opto sensor was not
failed
detected during the power-up pass-thru
module inventory.
M8501 and M8502 ACL Tape Drive Installation and User’s Guide — 529972-003
6- 11
...Other models in this manual:
Desktops - HP Integrity NonStop J-Series (1.48 mb)
Desktops - HP NonStop G-Series (1.48 mb)
Desktops - HP NonStop L-Series (1.48 mb)