2 Fig. 3 300 606 300 399 707 Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fig. 13 Fig. 14 Fig. 15 Fig. 16 Fig. 17 Fig. 18 GB .................................................................................................................................... 1 FR .................................................................................................................................... 6 PT ..............................................................................

Although the main lights operate immediately it will take a further 30 seconds before the fl ame eff ect starts. Press again to give fl ame effect and half heat. This will be indicated by two beeps. Press again to give fl ame effect and full heat. This will be indicated by three beeps. Press again to return to fl ame eff ect only. This will be indicated by one beep. Press to put stove in to standby mode. This will be indicated by one beep. Control Knob ‘C’:- Controls the intensity of the fl ame

Only pull out the drawer when its time to refi ll the water tank or change a lamp, otherwise it may lead to excess water in the sump and reduced fl ame eff ect. If this happens empty the water from the sump as instructed under ‘Maintenance’. 2. With the flame setting on minimum the unit will use approximately 40ml of water per hour and will last 3 times as long than when it is at maximum fl ame setting. 3. Do not tilt or move the stove while there is water in the tank or sump. 4. Make sure that

When the switch is in the ON position the heater operates if the thermostate calls for heat. C. HEATER THERMOSTAT CONTROL To adjust the temperature to your individual requirements, turn the thermostat control clockwise all the way to turn on the heater. When the room reaches the desired temperature, turn the thermostat knob counter clockwise until you hear a click. Leave in this position to maintain the room temperature at this setting. For additional heat, turn clockwise until you hear the clic

. . . . . . . . . . . . . . . . 4100040300RP 10. Upper Light Harness. . . . . . . . . . . . . . . 4200120400RP 11. Mirror. . . . . . . . . . . . . . . . . . . . . . . . . . . 5900060600RP 12. Reflector Assembly. . . . . . . . . . . . . . . . 5900080600RP 13. Front Glass. . . . . . . . . . . . . . . . . . . . . . 5900440100RP 14. Capacitor . . . . . . . . . . . . . . . . . . . . . . . .2300030100RP 15. Terminal Block . . . . . . . . . . . . . . . . . . . .4000070100RP 16. Control Knob . . . . . .

3. Remove all of the mounting screws on the heater cover and separate the cover from the heater and light assembly. 4. Locate the heater assembly and disconnect the wiring connections noting their original locations. 5. Remove heater mounting bracket screws and set aside heater assembly. 6. Properly orient the new heater assembly and connect all of the wiring clips and connections. 7. Reassemble in the reverse order as above. TO REPLACE THE POWER CORD • WARNINg: If unit was operating prior to se