For lubrication procedure, refer to manufacturer’s instructions. 2. On frame-mounted units, regrease at ,000 hours use or after 3 months. Use # Sodium or Lithium grease and fill until grease comes out of the relief fitting. 9. Disassembly 1. Always turn power off. 2. Drain system. Flush if necessary. 3. Remove motor hold-down bolts on close-coupled or disconnect coupling and remove spacer. 4. Remove casing bolts and pump hold-down bolts. 5. Remove motor and rotating element from casing. 6. Unscr

Engineered for life Table of Contents Owner’s Information SUBJECT PAGE Safety Instructions ...................................................................... 3 Important Instructions................................................................ 3 Installation .................................................................................. 3 Alignment ................................................................................... 4 Suction Piping.......................................

Engineered for life INDEX INDEX Index Important Safety Instructions ........................................................................................................3 System Components .......................................................................................................................4 System Design ................................................................................................................................5 Piping ....................................

Eff. TEFC 230/460 326TSC V18742SPE 108/54 124.8/62.4 422 1.15 94.1 F NOTES: . Locked rotor amps are for high voltage only. * Currently available on Packaged Hydrovar. • Motors are suitable for AQUAVAR® Variable Speed Drive. Above data is for Baldor® TC and TSC frame motors. Specifications subject to change without notice. PERFORMANCE WITH VARYING SPEED FOR CENTRIFUGAL PUMPS Fitting the electric pump with a variable speed drive makes it possible to vary the pump rotation speed, normally according