If you sell or pass the appliance to someone else, or move house and leave it behind, make sure this Book is also provided so the new owner can become familiar with the appliance and safety warnings. Fig. 1 Fig. 1b Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 REINFORCEMENT STRIP TO BE FITTED FLUSH TO GRILL AS SHOWN REINFORCEMENT STRIP Fig. 1 Fig. 1b Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 REINFORCEMENT STRIP TO BE FITTED FLUSH TO GRILL AS SHOWN REINFORCEMENT STRIP TO BE POSITIONED CENTRALLY ON THE GRILL Fig. 7

* The guarantee is subject to the provisions that the appliance: (a) Has been used solely in accordance with the Users Instruction Book. (b) Has been properly connected to a suitable supply voltage and gas supply as stated on the rating plate attached to this equipment. (c) Has not been subjected to misuse or accident or been modified or repaired by any person other than the authorised employee or agent. (d) Has been correctly installed. 3 FP089-01 Creda Gas Hob (W810) 12/09/2001 5:02 pm Page 4

If you sell or pass the appliance to someone else, or move house and leave it behind, make sure this Book is also provided so the new owner can become familiar with the appliance and safety warnings. Fig. 1 Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 7Fig. 6 Fig. 8 Fig. 5 A. Please read these instructions carefully before you begin 1. The microwave oven can be installed into a 600mm wide Cabinet. The installation cavity must have the following internal dimensions: Height: 450mm (± 2mm) Width: 560mm to (± 5

REPLACING THE GREASE FILTER 1. Push the wire clips to one side and remove (Fig.10). Fig.10 2. Remove the saturated grease filter. 3. Place the new grease filter in the filter grille (Fig.11). Fig.11 4. Replace the retaining clips. 5. Close the grille panel. THE CARBON FILTER ( Recirculation only) The activated carbon filter absorbs odours arising from the cooking. In use, the filter will slowly become saturated and gradually less effective. The filter will normally require changing every four mo

• The diameter of the pans must match the diameter of the cooking zone so that all the available heat can be used. • Avoid at all costs all cookware with irregular rough bases which could scratch the glass surface. • It is preferable that you cover your cookware with a suitable lid to speed up the rise in temperature. Maintenance The vitroceramic glass used for the heating surface is smooth and poreless and it is also resistant to thermal shocks and to mechanical shocks under normal conditions o

The cut-out device will reset itself when the fan motor has cooled significantly. NOTE: This hood has been designed and approved for installation over an electric hob with a maximum input of 7kW or a gas hob with a maximum input of 10kW when fitted in accordance with the heights recommended above. Your Cooker Hood can be installed either for recirculation back to the room or extraction through an outside wall. When used in the extraction mode the Cooker Hood ducting must not be connected to a fl

To the User You must read the instructions prior to installing and using the appliance and then retain them for future reference. - 1 You have just purchased a glass ceramic hob featuring halogen and radiant cooking zones.You will now be able to benefit from the four assets of halogen cooking: • Top performance -The infrared radiation ensures the immediate transmission of heat.The rapid rise in temperature and the poor thermal inertia of the halogen cooking zones allow for guaranteed control fle

Electrical Requirements Any permanent electrical installation must comply with the latest I.E.E. Regulations and local electricity company regulations. For your own safety, this should be undertaken by a qualified electrician eg. your local electricity company or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC). Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown

Fix the wall brackets. 2. Fix the canopy hood. 3. Connect the hood to the mains supply ensuring that the canopy is functioning correctly. 4. Select the type of installation, ie. ducting or recirculation. 5. Fix the chimney stack. NOTE: The hood is more efficient in the exhaust mode, therefore, this position should be selected during the warmer months of the year when no heating is being used. When the room is being heated, if the recycle position is selected heat will not be wasted. Installing y

Do install the hood at the correct height, allowing at least the minimum distance above a cooking appliance (see page 5). Fan Speed The right slider enables you to select the fan speed. Your Cooker Hood has three speeds to give you the correct extraction level to suit your cooking conditions. Position 1 should be selected when simmering or when using only one pan. Position 2 should be selected for normal cooking up to four pans. Position 3 should be selected when frying or cooking food with stro