Operator Training – Personnel who have not been trained to operate powered units may operate a unit for the purposes of training only, and only under the direct supervision of the trainer. This training should be conducted in an area away from other units, obstacles, and pedestrians. – The operator training program should include the user’s policies for the site where the trainee will operate the unit, the operating conditions for that location, and the specific unit the trainee will operate. Th

Before operating the unit, operators shall have read and be familiar with the operator’s manual for the particular unit being operated and they shall also abide by the safety rules and practices in the following paragraphs. Before operating any unit, the operator shall be familiar with unusual operating conditions which may require additional safety precautions or special operating instructions. General Before operating make sure the unit is in the operating position. Do not start or operate the

AirMover™ 3 WindHandler™ 3 Portable Blower Machines Three speed versatility and power reduces carpet drying times by up to 50% Your choice of: • The economical standard AirMover 3 with molded handle, or • The WindHandler 3 with upright handle and transport wheels for added safety and convenience Both models offer: • 3 speeds of air movement for every type of job • A maximum air movement of 3,000 cfm for rapid drying of carpet and hard floors • Sturdy, four point motor mount to withstan

x 9.1" (23 cm) wide Same Fan Speeds: High - 1600 rpm Same Medium - 1350 rpm Same Low - 1050 rpm Same Airflow: High - 3000 cfm (84 m3/min.) Same Medium - 2500 cfm (70 m3/min.) Same Low - 2000 cfm (56 m3/min.) Same Power Cable: 25 ft (7.6 m) 16/3 SJTW with three-wire molded plug Same Electrical: 120 volt AC, 60 Hz Same Dimensions: Length 20" (51 cm) 22.8 (58 cm) Width 16" (41 cm) 16” (41) Height 18.8" (48 cm) 21.5 (55 cm) Weight: 33.5 lbs (15 kg) 39 lbs (18 kg) Approvals: UL Li

B Grandview, MO 64030-2837 Phone: 816-763-3100 Table of Contents Introduction ............................................................................... 1 Description of Features ............................................................ 2 Typical Components ................................................................. 3 Operating Instructions -Landing Controls .................................................................. 4 -Car Controls...........................................