Login:
Sorted: Name ↑   Downloads   Rate   Size ↓  

CFM Corporation 36C03U TYPE 139

downloaded: 0File size: 167 kb    Manafacture: CFM Corporation  
Category: Fireplaces

Min inlet pressure : 5 11 in w.c. Max inlet pressure : 7 14 in w.c. Vent size : 4” Diam. listed gas liner Valve : Natural gas Propane White Rogers Robertshaw Model 36C03U TYPE 139 Model 7000 MVRLC Millivolt operated Millivolt operated SIT SIT Nova model Nova model Millivolt operated Millivolt operated Blower : Variable speed, 140 CFM Thermo-switch : 120° F “ON” 110° F “OFF” bi-metal type Efficiency : 74% heating Clearances to combustibles : mantel : 10” from top of face place side wall : 0” from

CFM Corporation 7000 MVRLC

downloaded: 0File size: 167 kb    Manafacture: CFM Corporation  
Category: Fireplaces

* The glass used on your fireplace is a high temperature ceramic 5 mm thick with a special coating for use with gaseous fuels. Do not replace it with any other material. CAUTION : Do not operate your fireplace without a glass or with a broken glass. BURNER REMOVAL AND INSTALLATION : REMOVAL : 1. Slide the burner to the left and pull toward you. 2. To gain access to the fan, also remove the firebox bottom plate. INSTALLATION : 1. Put the bottom plate back in place. 2. Put the burner assembly back

CFM Corporation Nova 820

downloaded: 8File size: 204 kb    Manafacture: CFM Corporation  
Category: Fireplaces

• Provide adequate accessibility clearances for servicing and proper operation. • Provide adequate clearances around air openings into the combustion chamber.. • This appliance has a built-in draft hood, so no additional external draft hood is required. • If installing in a factory built fireplace, you may remove the damper, glass doors, screen, screen holder, baffles, and smoke shelf provided that what you take out can be reinstalled. Also you must retain the pieces you have removed, in case so

CFM Corporation Adirondack

downloaded: 2File size: 284 kb    Manafacture: CFM Corporation  
Category: Fireplaces

If you are using a factory built chimney, it must comply with UL 103 or ULC S629 standards; therefore it must be a Type HT (2100°F). It is extremely important that it be installed according to the manufacturer's specifications. If you are using a masonry chimney, it is important that it be built in compliance with the specifications of the National Building Code. It must be lined with fire clay bricks, metal or clay tiles sealed together with fire cement. (Round flues are the most efficient). Th

CFM Corporation ElDorado

downloaded: 1File size: 284 kb    Manafacture: CFM Corporation  
Category: Fireplaces

The instructions pertaining to the installation of your wood stove comply with ULC-S627 and UL-1482 standards. Read this entire manual before you install and use your new stove. If this stove is not properly installed, a house fire may result. To reduce the risk of fire, follow the installation instructions. Failure to follow instructions may result in property damage, bodily injury, or even death. Consult your municipal building department or fire officials about restrictions and installations

CFM Corporation Celtic

downloaded: 2File size: 284 kb    Manafacture: CFM Corporation  
Category: Fireplaces

Stove Pipe TYPICAL INSTALLATIONS FACTORY BUILT CHIMNEY: ROOF FLASHING18" CLEARANCEWALL SUPPORTWALL RADIATION SHIELDRAIN CAP Wall installation CEILING SUPPORTRADIATION SHIELD Vertical installation MASONRY CHIMNEY: Clay liner Thimble Clean out door FACTORY BUILT THIMBLE: BRICK THIMBLE: OUTSIDE COMBUSTION AIR Your DROLET stove is approved to be installed with an outside air intake which is necessary for a mobile home. This type of installation is also required in air tight houses and houses with ne

CFM Corporation Jurassien

downloaded: 7File size: 284 kb    Manafacture: CFM Corporation  
Category: Fireplaces

2. Slide the ash pan in position. Side Panels and Ash Lip Installation: 1. Start by fixing the front part of the decorative side in the two clips welded on the sides of the fire box. 2. Then, fix the back of the decorative side with two screws and washers supplied. Line up the decorative side parallel to the side of the appliance. 3. Clip the ash lip into position, centred just below the door. LEGS AND ASH PAN Ash Lip Installation : 1. Just clip the ash lip into position, centred just below the

CFM Corporation Savannah

downloaded: 7File size: 284 kb    Manafacture: CFM Corporation  
Category: Fireplaces

A wood stove must never be installed in a hallway or near a staircase, since it may block the way in case of fire or fall to respect required clearances. FLOOR PROTECTOR Your wood stove should be placed on a non-combustible surface. The floor protector should be under the stove, eighteen inches beyond the front and eight inches beyond each side of the fuel loading and ash removal opening. If there is a horizontal section of chimney connector, the floor protector should go under it and two inches

CFM Corporation PVS-1

downloaded: 2File size: 286 kb    Manafacture: CFM Corporation  
Category: Fans

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. FOR YOUR SAFETY If you smell gas: • Do not try to light any appliance. • Do not touch any electric switch; do not use any phone in your building. • Immediately call your gas supplier from your neighbors phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. • Open windows / Extinguish all flames. Homeowner’s Installation & O

CFM Corporation Ultra Flame DG05437/DG05447

downloaded: 2File size: 303 kb    Manafacture: CFM Corporation  
Category: Fireplaces

The vent terminal shall not terminate : • Within 3 ft. of a building mechanical air supply. • Less than 12 inches from a perpendicular wall. • In an area which is allocated to the occupancy. • Under a window that pivots open. In addition, in a structure with three walls and a roof , the following restrictions apply: a) The minimum distance between the two side walls must be 72". b) The roof must not exceed the walls more than 24". c) If both those conditions apply, the clearance shall be as foll





Category