Click the “Trust in the text” or “Play” button to close the message. Click the screen again to play the movie. Next CATEYE URBAN WIRELESS Quick Start Manual Contents Click the item you wish to view. r V. "N Setting up the computer V. How to install the bracket (movie) V. How to install the speed sensor (movie) Operation of buttons Set up the computer by operating the bu Check the button position before you sta Front MODE Press the MODE button on the front of the computer. tton

Upright Type (w/o Flywheel)-- Upright Type (with Flywheel)---------------------------------------- 2. Recumbent Type (EC-3600 & EC-3700)-------------------------- 3. Belt Drive (EC-1200B, EC-1600B, EC-3600B & EC-3700B) Circuit Diagram--------------------------------------------------------------- Part A ® Symptoms of Problems & Causes T-1 T-2 T-3 T-4 T-5 T-6 T-7 No Display on Control Unit after Power ON ■ No Display of Cadence----------------------------- No Display of Pulse Rate

(See the Sections D-1 & D-2 "Removing the Frame Covers.") 2. Detach the CN-3 connector from the power supply board. (Fig. 1) 3. Cut the cable holders which fix the CDC sensor cable to the frame. 4. Remove the defective CDC sensor set by loosening the screws, and mount and fix the brandnew CDC sensor set. (Fig. 2) 5. Perform the following adjustments. (Figs. 3 and 4) © Align the line on the CDC sensor with the center of the line on the CDC magnet. (Fig. 3) © Adjust the gap between the surfa

C-Shape Brace Remove the axle nut and washer from the rear wheel axle. Place the brace stabilizer washer onto the axle and align the washer so that the notch on the washer fits into the rear frame drop out. Next, place the C-shaped wheel brace onto the axle and replace the washer and axle nut. Tighten the axle nut securely, making sure that the wheel brace stays in the proper vertical position. The elongated hole on the wheel brace allows the training wheel height to be adjusted for proper fit.