The obligation of Bush Hog to the purchaser under this warranty is limited to the repair or replacement of defective parts. Replacement or repair parts installed in the equipment covered by this limited warranty are warranted for ninety (90) days from the date of purchase of such part or to the expiration of the applicable new equip- ment warranty period, whichever occurs later. Warranted parts shall be provided at no cost to the user at an authorized Bush Hog dealer during regular working hours

4. Input Gearbox -Add EP80W-90 gear oil, if necessary, to bring oil level to check plug. 5. Lateral Gearbox -RTH Models (Gear Drive) -Add EP80W-90 gear oil, if necessary, to bring oil level to check plug located on side of gearbox. 6. Chain Drive -RTN,RTNR Models -Add EP80W-90 gearoil, if necessary, to bring oil level to check plug located on side of cover. 40 HOURS 7. Rotor Shaft Bearing -Apply 2-3 shots of multi- purpose grease with hand pump grease gun every 40 hrs. of operation and before st

Traveling at the slowest forward speed with rear shield fully lowered will give finest possible finish. This shield adjustment is good for mulching, mixing, and burying weeds, fertilizer, etc. The more you increase forward speed and shield height, the coars- er the finished results will be. To leave the ground surface rough with larger clods and residue exposed, work with shield fully raised. When working in rocky soil, always have shield in raised position. Figure 3-1 Adjustments Adjustable, Sp

• Selma, AL 36703 (334) 874-2700 Parts Ordering 1-800-304-2836 Fax 1-800-572-1784 BUSH HOG / MATERIAL HANDLING REPAIR PARTS MANUAL SEPTEMBER, 2006 3045 MID-MOUNT LOADER ALPHABETICAL INDEX CONTENTS PAGE Bucket Assemblies....................................................................................................................................1-20D-1 Exhaust Relocator Kits................................................................................................................

ALWAYS stop the engine immediately and check for damage if you strike a foreign object or if the unit becomes tangled. Do not operate with broken or damaged equipment. NEVER allow the engine to run at high RPM without a load. Doing so could damage the engine. NEVER operate a unit with worn or damaged fasteners or attachment holders. Shoulder Strap C2510 IMPORTANT! Adjust the shoulder strap so the shoulder pad rests comfortably on the off-side shoulder and the cutting path of the cutting attachme

DITCH SOIL PILE Leave dirt which drifts over the side of the bucket for final clean-up. DITCH Pile dirt on the high side for easier backfilling on a slope. 20 HANDLING LARGE HEAVY OBJECTS WARNING Do not use front end loaders for handling large heavy objects such as logs or oil drums. Handle large round hay bales only when loader is equipped with Bush Hog Bale Spear Attachment. Handling large heavy objects can be extremely dangerous due to: Possibility of rolling the tractor over. Possibility o

5. During operation, listen for abnormal sounds which might indicate loose parts or other damage. AFTER EACH USE 1. Clean all debris from machine, especially cylinder rods and affixed safety decals. Replace any missing or illegible decals. 2. Inspect loader for worn or damaged components. Repair or replace before next use. Any replace- ment components installed during repair shall include the components’ current safety decals specified by the manufacturer to be affixed to the component. 3. Store

1530 lbs. 2900 lbs. VV. Rollback Force at Maximum Height 31.5” Forward of Pivot Pin 1935 lbs. 1625 lbs. 2300 lbs. XX. Rollback Force at 59” Height 31.5” Forward of Pivot Pin 2300 lbs. 2020 lbs. 3400 lbs. ZZ. Rollback Force at Ground Level 31.5” Forward of Pivot Pin 1700 lbs. 1680 lbs. 2800 lbs. Raising Time - Ground Level to Full Height 3.5 sec. 3.8 sec. 5 sec. Lowering Time - Full Height to Ground 2.5 sec. 2.3 sec. 3 sec. Bucket Dumping Time -Full Rollback to Full Dump 4.0 sec. 3.3 sec. 4 sec.

3. If parts not made or supplied by Bush Hog have been used in connection with the unit, if, in the sole judgement of Bush Hog such use affects its performance, stability or reliability. 4. If the unit has been altered or repaired outside of an authorized Bush Hog dealership in a manner which, in the sole judgement of Bush Hog, affects its performance, stability or reliability. 5. To normal maintenance service and normal replacement items such as gearbox lubricant, hydraulic fluid, worn blades,

C. Move Control Levers to neutral position and then to the “OUT” position. D. Set the parking brake. E. Turn ignition key to “OFF” position. F. Remove the key and wait for all movement and sound to cease before dismounting. ANTI-SCALP ROLLER WARNING Use EXTREME caution when mowing and/or turning on slopes as loss of traction and/or tip-over could occur. Drive slower on slopes. DO NOT mow slopes greater than 15 degrees. Watch for ditches, holes, rocks, dips and rises, which change the operating a