Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
HP NetServer LH 3000/3000r
D8228-80201, Rev A
BARCODE AREA
A
System Board Assembly
Cabinet
See :
B
Board Stiffener
Caution: DO NOT operate server for more than
60 minutes with any cover (including Power
System Board
Supply and Disk Drive) removed. Over-
temperature may cause component damage.
I/O Connectors
Processor Fan
Primary
Processor Cage
I/O Connectors
Processor
Cover
See B
Secondary
Processor Slot
(Terminator in Place)
DIMM Slots
PCI Slots:
Non-Hot-Swap
1
Exhaust Fans
Shelves:
2
3
Shelf 1:
4
Flexible Disk Drive
Air Baffles
5
Shelf 2:
6
CD-ROM
7
Shelves 3 & 4:
8
Optional Mass
Storage Devices
Front Panel Console Reset (located under cover)
Lock
Power
Keyboard Lock
and Indicator
and Indicator
Reset
Server Status
LEDs
4
Unused
3
Optional Redundant
2-Line Display
2
Power Supply Slot
Hot-Swap Mass Storage:
Select
1
Power Supply Connector
Back
Not Used Scroll 2-Line Display
and Strain-Relief
Secondary Cage
(Optional)
Power
Pair A
Power Supplies
Supply Pair B
Primary Slots (1- 6 )
Fans:
Note: See HP NetServer LH 3000/3000r
C Quick Reference
Installation Guide
B System Board Assembly
Primary Voltage Regulator
Module (VRM)
Boot Order
Default Boot Order
LED Interpretation
DIMM Installation
Primary Processor
Secondary VRM
1. IDE CD-ROM Drive
Off = No Power, or Normal
• Use up to 4 HP SDRAM DIMMs in sizes
Secondary Processor
Slot
2. Flexible Disk Drive
Green Solid = Normal, or Power On
of 128MB, 256MB, 512MB, and 1GB.
Slot (Upgrade)
3. Embedded SCSI
4. Other SCSI Device
Green Flashing = Normal Activity
• First DIMM is supplied in Slot 0.
(Settable)
Only Green Flashing (RJ-45) = 10 Mbps
Temperature
Amber (HDD) = Failure Predicted
• You can add DIMMs to Slots 1, 2, or 3
Sensors:
CMOS Battery
in any order.
Yellow Flashing = Pre Failure Condition
Primary (U18)
Configuration
Amber (PCI Slot) = Slot Needs Attention
• Maximum system size is 4GB.
(Under Processor)
Switches
Yellow (RJ-45) = LAN is 100 Mbps
• You can insert any approved size DIMM
Serial
in any DIMM slot.
Secondary (U17)
Red Solid = 12 V Failure
Red Flashing = Failure, Immediate Attention
Parallel
Terminator
Audience Assumptions
Electrostatic Discharge
0
I/O Connectors
Mouse
This Technical Reference Card is for trained
To avoid catastrophic or hidden damage to
1
DIMM Memory
Keyboard
service personnel. Hewlett-Packard Company
components, wear a wrist strap and use a static-
Sockets
assumes you are qualified in the servicing of
dissipative work surface connected to the chassis
2
LAN
computer equipment and trained in recognizing
when handling components. Use an antistatic
3
hazards in products with hazardous energy
service kit, such as 3M® 8501/8502/8505 or
Video
levels.
equivalent.
This information is subject to change without
notice and is provided without warranty.
© Copyright 1999 Hewlett-Packard Company
For additional information, see other side.
...Other models in this manual:
Desktops - HP NetServer LC 2000 (248.72 kb)
Desktops - HP NetServer LC 2000r (248.72 kb)
Desktops - HP NetServer LC II (248.72 kb)
Desktops - HP NetServer LC Plus (248.72 kb)