Votes - 4, Average rating: 4.3
(
)
)
|
manual abstract
The indicator light for the filter will go off. To reset the filter indicator after replacing the filter, if one or both lights are on: press and hold the FILTER RESET button for 2 seconds. One or both indicator lights will go off. Remote Control – Model AFHC21AM Only Power On/Off Button Power On/Off SPEEDTIMERFan speed Press to turn the air purifier on and off. adjustment button button Timer adjustment Fan Speed Adjustment Button button Press to adjust the fan motor speed setting. Press to select from levels 1 (low) to 4 (high). Timer Adjustment Button Press to select from timer hour settings 1 hr., 2 hr. or 4 hr. The air purifier will run for the selected number of hours and then turn off. Battery clip Battery Remote body Battery – CR2025 Install the battery that comes with the remote control. Remove the clip from the end of the remote control. Install the battery into the clip. Replace the clip into the remote control. 3 Consumer Support Troubleshooting TipsOperating InstructionsSafety InstructionsTroubleshooting Tips Care and Cleaning Safety InstructionsOperating Instructions About the air purifier. Product Identification Control panel SPEEDTIMER Handle Remote control Ventilation outlet sensor (Model AFHC21AM only) Ventilation inlet Rating label Front cover Remote control (Model AFHC21AM only) Product Features Power cord Compact Size and Powerful Air Cleaning This air purifier uses a True HEPA Filter to maximize the efficiency of air cleaning. It removes 99.97% of airborne particles 0.3 microns or larger that pass through the filter. Optional Activated Charcoal Filter The Charcoal Filter helps eliminate food odors and unpleasant smells from the room. This filter is optional. Washable Pre-Filter The permanent Pre-Filter prolongs the life of your 99.97% True HEPA Filter by trapping large particles in the air initially. Filter Replacement Timer This air purifier will let you know when it is time to replace your filters for maximum air cleaning. High Airflow Rate and Low-Noise Fan This air purifier has a high airflow rate with a low-noise fan to reduce pollutants in the air with minimal noise. Design This air purifier has a switch that is installed to turn off the unit if the front cover is opened. Remote Control Model AFHC21AM has a remote control to allow you to control the air purifier from across the room. 4 ge.com Air Filtration System 99.97% True HEPA Filter Charcoal Filter (optional) Pre-FilterFront cover Installation Location ¦ Your air purifier has a minimum clearance requirement of 8. from the sides and back and a minimum clearance of 24. from the top. ¦ This appliance is not to be mounted on a wall or in a window. ¦ Do not block the front cover and/or ventilation outlet or inlet. This could cause a fire hazard and will reduce the effectiveness of the unit. ¦ WARNING: Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners or similar coverings. Do not route the cord under furniture or appliances. Arrange the cord away from traffic areas and where it will not be tripped over. 8.min. 8.min. 24.min. Consumer SupportTroubleshooting Care and Cleaning 5 Consumer Support Troubleshooting TipsOperating InstructionsSafety InstructionsTroubleshooting Tips Care and Cleaning Safety InstructionsOperating Instructions Using the air purifier. Packaging must be removed from the HEPA Filter before using your air purifier for the first time. Pull the top of the front cover toward you and lift up slightly to remove. Pull forward on the black Pre-Filter, using the pull tabs in the middle, and remove it from the unit. Pull tabs Gently pull forward on the 99.97% True HEPA Filter to remove it from the unit. Remove the plastic shipping cover from the filter and discard. Replace the 99.97% True HEPA Filter in the unit. If you are choosing to use the Charcoal Filter, install it in the back of the Pre-Filter now. Slide the Charcoal Filter under the tabs on the back side of the Pre-Filter. Install with the Charcoal Filter facing the 99.97% True HEPA Filter. 6 ge.com Insert the side tabs of the Pre-Filter into the slots of the unit; pull tabs should be to the outside. Push the Pre-Filter to snap into place. Insert the tabs at the bottom of the front cover into the recesses of the unit body. Push forward on the top of the front cover to snap it into place. Operating Instructions Locate the air purifier for maximum effectiveness (see Location on page 5). Plug the power cord into a receptacle that meets the requirements on the rating plate. Push the POWER button and set for the desired airflow. Consumer SupportTroubleshooting Care and Cleaning 7 Care and cleaning of the air purifier. Turn off the air purifier and remove the plug from the wall outlet before cleaning. Consumer Support Operating InstructionsSafety InstructionsTroubleshooting Tips Care and Cleaning Safety InstructionsOperating Instructions Front Cover and Body To clean: Use a soft cloth to clean the front cover and body. For stubborn dirt,...