Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
6.
Remove the elastomer jacket that is under the front UID by squeezing
8.
Remove the interconnect cable by unplugging the connector from
the upper and lower clips and pulling it off the enclosure (see Figure
the interconnect board (1, Figure 6) and from the midplane board
4).
at the other end.
NOTE:
Your kit includes a spare jacket in case you misplace
the one removed.
3
1
2
15811
Figure 6 Removing the power on/off board
9.
Loosen the thumbscrew on the interconnect board (2).
10. Slide the board back to remove it from the guide (3), and then lift
it out of the enclosure.
15823
Figure 4 Removing the elastomer jacket
Installing the interconnect board
7.
Remove the power supply behind the interconnect board.
1.
Insert the replacement board into the guide that extends into the
hard drive bay.
a.
Move the mounting latch to the left (1, Figure 5), grasp the
handle, and pull the power supply slightly out of the enclosure
2.
Tighten the thumbscrew to secure the board to the enclosure.
(2).
3.
Press the elastomer jacket into the enclosure slot so it makes contact
b.
Position one hand under the power supply, and with the other
with the interconnect board.
hand, pull the power supply out of the enclosure.
4.
Plug in the new interconnect cable by attaching one end to the
midplane board and the other end to the interconnect board.
5.
Set the top access panel on the enclosure, and secure the access
panel latch.
6.
Reinstall the power supply behind the interconnect board.
7.
Install the front UID module.
1
8.
Reinstall the enclosure into the rack and attach the bezel ears.
9.
Reattach the power and data cables to the enclosure components.
10. Press the Power On/Standby button on the power UID bezel (located
at rear of enclosure) and hold it down long enough to power up
the enclosure.
2
11. For the EVA4400 only: Power up any other disk enclosures attached
to the array by pressing their Power On/Standby button on the
power UID bezel. After power has been applied to all disk
enclosures, then apply power on the controller enclosure using the
power button on the power UID bezel.
Figure 5 Removing a power supply
Verifying proper operation
After replacing the interconnect board, verify proper operation using
the following methods:
Page 3
...Other models in this manual:
Media Storage - HP 4400 Dual Controller Enterprise Virtual Array (678.8 kb)
Media Storage - HP EVA6400 Array (678.8 kb)
Media Storage - HP EVA6400 for Storage Centric Rack (678.8 kb)
Media Storage - HP EVA8400 Array (678.8 kb)