6. Never attempt to unclog the collection system until the mower’s engine engine has been shut off and all moving parts have come to a complete stop. 7. Do not stand behind the vent at the rear of the collection system due to the potential for small pieces of blowing debris to escape through the vent. 8. Wear eye and ear protection. 12 SERVICE AND MAINTENANCE Transport WARNING The collection system bags must be completely empty or removed while driving forward onto a trailer. If the mower must b

. . . . . . . . . . . . . . . . . . . . . . . .17CONTROL ARM [150BF/170BF/180BF] . . . . . . 17 STARTING ENGINE. . . . . . . . . . . . . . . . . . . . . .17 ADJUSTING IDLE SPEED. . . . . . . . . . . . . . . . . 18 STOPPING ENGINE . . . . . . . . . . . . . . . . . . . . .18 Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19 AIR CLEANER . . . . . . . . . . . . . . . . . . . . . . . . . .19 FUEL FILTER . . . . . . . . . . . . . . . . . . . . . . . . .

• Checkbrakeoperationfrequently.Adjustand service as shown in the Operator’s Manual. WARNING! WARNING! 7 UNPACKING INSTRUCTIONS • Remove all parts and packing materials from carton. TOOLS REQUIRED • 7/16" Wrench or ratchet and socket • ." Wrench or ratchet and socket • 7/8" Socket • Torque Wrench • Phillips Head Screwdriver • Hacksaw • Pliers • Drill and 7/8" bit NOTE: When right hand (R.H.) and left hand (L.H.) are mentioned in this manual, it means when you are seated on the mower in the opera

English 115 24 05-95 English FEDERAL EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The EPA (The US Environmental Protection Agency), CARB (California Air Resources Board), Environment Canada and Husqvarna Forest & Garden are pleased to explain the emissions control system warranty on your 2007 and later small nonroad engine. In U.S. and Canada, new small nonroad engines must be designed, built and equipped to meet the federal stringent anti- smog standards. Husqvarna F

Other symbols/decals on the machine refer to special certification requirements for certain markets. IMPORTANT If the warning label peels off or becomes soiled and impossible to read, you should contact the dealer from which you purchased the product to order new labels and affix them in the required location(s). English Symbols on the machine (d)(a) (b) (c) For safe operation and maintenance, symbols are carved in relief on the machine. Using to these indications, please be careful not to make

E EEEEn nnnng ggggl lllli iiiis ssssh hhhh INTRODUCTION Dear Customer, Congratulations on your choice to buy a Husqvarna product! Husqvarna is based on a tradition that dates back to 1689, when the Swedish King Karl XI ordered the construction of a factory on the banks of the Husqvarna River, for production of muskets. The location was logical, since water power was harnessed from the Huskvarna River to create the water- powered plant. During the more than 300 years of beeing, the Husqvarna fact

Always stop the engine and let it cool for a few minutes before refueling. When refueling, open the fuel cap slowly so that any excess pressure is released gently. Tighten the fuel cap carefully after refueling. Always move the machine away from the refueling area before starting. English- ---11 STARTING AND STOPPING Min.10ft. (3m) SCleantheareaaroundthefuelcap. Contaminationinthetankcancauseoperatingproblems. SEnsurethatthefueliswellmixedbyshak- ingthecontainerbeforefillingthetank. Starting and

• Observe the surroundings and ensure that no people or animals can come into contact with the blower. • Place the machine on the ground, press the machine body against the ground with your left hand (NOTE! Not with your foot). Then grasp the starter handle with your right hand and pull the cord. Fuel safety • Always use a fuel container with an anti-spill valve. • Never refuel the machine while the engine is running. Always stop the engine and let it cool for a few minutes before refuelling. •

8. The ignition system of your unit produces an electromagnetic field of a very low intensity. This field may interfere with some pacemakers. To reduce the risk of serious or fatal injury, people with pacemaker should consult their physician and the pacemaker manufacturer before operating this tool. WORKING CIRCUMSTANCE 1. To reduce the risk of injury associated with exhaust fume inhalation, do not operate in unventilated area. The exhaust gases contain harmful carbon monoxide. 2. Avoid using th

Veiller à une bonne aération pendant toute manipulation de carburant._ Petrol • Use good quality unleaded or leaded petrol. • The lowest octane recommended is 90. If you run the engine on a lower octane grade than 90, so-called knocking can occur. This gives rise to a high engine temperature, which can result in serious engine damage. ° For work with continuously high revs a higher octane rating is recommended. Benzin * Bleifreies oder verbleites Qualitätsbenzin verwenden. « Als niedrigst