This document provides information about the B.11.31.1203 release of the FibrChanl-03 (fcoc)
Fibre Channel Mass Storage Driver for HP-UX 11i v3.
FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3
overview
This release of the document for the FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for
HP-UX 11i v3 (version B.11.31.1203) documents defect fixes and version changes.
New and changed features in this release
New features
There are no new features in this release.
Known problems fixed in this version
These issues have been fixed in the FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for
HP-UX 11i v3 March 2012 (AR1203) release.
Table 1 HP-UX March 2012 (AR1203) Fixes
Defect ID
Description
QXCR1001144340
This fixes a timing-related hang issue in the FCOC driver that may occur when the driver is being
unloaded.
QXCR1001146915
This fixes fcocutil to print correct SFP information or print appropriate error message.
QXCR1001126158
This corrects a resource issue that may result in the FCOC driver never coming online after
repeated disables, enables, and resets, and subsequently being stuck in
"AUTHENTICATION/DISCOVERY" state as reported by fcmsutil
QXCR1001103767
This corrects a resource issue that may result in a system panic during FCOC driver unload.
QXCR1001158686
This corrects an issue that may result in a system panic during FCOC driver unload.
QXCR1001159017
This fixes a FCOC dump failure when crossing every 4GB page boundary.
QXCR1001115144
This corrects an issue that may result in the FCOC driver hanging during unload.
QXCR1001159730
This fixes an issue where the moduload fails to unload fc module because it is busy.
QXCR1001171646
This corrects a system panic that may occur when a target path goes offline.
QXCR1001175013
This change corrects a driver issue that intermittently caused an HBA hang during a reset sequence.
QXCR1001177226
This corrects a system panic that may occur when a target controller becomes less responsive.
QXCR1001180904
This corrects an FCOC driver issue that may result in a system panic when a target controller
becomes less responsive.
QXCR1001119607
This fixes the issue where fcmsutil would incorrectly display the Previous Topology as
UNINITIALIZED when the link goes down for the first time after the system was booted or after
the driver was reloaded.
Table 2 HP-UX August 2011 (WEB1108) Fixes
WEB1108 supersedes the AR1109 release.
Defect ID
Description
QXCR1001137610
This addresses issues in the driver's IO state machine.
QXCR1001124369
This enhances the driver's interrupt handling capabilities.
QXCR1001141630
This fixes a failure case in dma mapping.
FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 overview
3

---

...

Other models in this manual:
Network Equipment - HP Fibre Channel Host Bus Adapters (612.63 kb)
Network Equipment - HP-UX 11i v3 I/O Cards (612.63 kb)