Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
Table 3 HP-UX March 2012 (AR1203) Fixes
Defect ID
Description
QXCR1001144340
This fixes a timing-related hang issue in the FCOC driver that may occur when the driver is being
unloaded.
QXCR1001146915
This fixes fcocutil to print correct SFP information or print appropriate error message.
QXCR1001126158
This corrects a resource issue that may result in the FCOC driver never coming online after
repeated disables, enables, and resets, and subsequently being stuck in
"AUTHENTICATION/DISCOVERY" state as reported by fcmsutil
QXCR1001103767
This corrects a resource issue that may result in a system panic during FCOC driver unload.
QXCR1001158686
This corrects an issue that may result in a system panic during FCOC driver unload.
QXCR1001159017
This fixes a FCOC dump failure when crossing every 4GB page boundary.
QXCR1001115144
This corrects an issue that may result in the FCOC driver hanging during unload.
QXCR1001159730
This fixes an issue where the moduload fails to unload fc module because it is busy.
QXCR1001171646
This corrects a system panic that may occur when a target path goes offline.
QXCR1001175013
This change corrects a driver issue that intermittently caused an HBA hang during a reset sequence.
QXCR1001177226
This corrects a system panic that may occur when a target controller becomes less responsive.
QXCR1001180904
This corrects an FCOC driver issue that may result in a system panic when a target controller
becomes less responsive.
QXCR1001119607
This fixes the issue where fcmsutil would incorrectly display the Previous Topology as
UNINITIALIZED when the link goes down for the first time after the system was booted or after
the driver was reloaded.
Table 4 HP-UX August 2011 (WEB1108) Fixes
WEB1108 supersedes the AR1109 release.
Defect ID
Description
QXCR1001137610
This addresses issues in the driver's IO state machine.
QXCR1001124369
This enhances the driver's interrupt handling capabilities.
QXCR1001141630
This fixes a failure case in dma mapping.
QXCR1001146801
This fixes the dump driver's incorrect what string.
QXCR1001174447
Added Fibre Channel support for the CN1100E HBA.
QXCR1001174449
Added Fibre Channel support for the NC553M HBA.
Table 5 HP-UX September 2011 (AR1109) Fixes
Defect ID
Description
QXCR1001122377
This fixes the issue where the fcoc driver may panic with “Bad News!” when a fcmsutil command
is being executed while DLKM unload operation is in progress.
QXCR1001129474
This fixes the issue where the fcoc driver may panic with “Bad News!” when concurrent fcmsutil
stat commands are being run.
QXCR1001081641
This fixes the issue where, after performing a port disable/enable sequence with fcmsutil, the
fcmsutil get remote all command would not display the correct data.
QXCR1001083098 The System Management Homepage will now display the correct SLI version in the HBA Adapter
Firmware Version field.
QXCR1001115601
The maximum IO size supported by the controller has been set at 1MB.
4
...Other models in this manual:
Network Equipment - HP Fibre Channel Host Bus Adapters (593.72 kb)