Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  
downloaded: 2   File size: 6 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces
@name

Note: If only the blower option is to be installed, wiring may be performed as described and illustrated in the following Blower Installation section. Page 26 26670-0-0110 Attention: Install blower assembly before connecting gas inlet supply line. Wiring The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, if an external electrical source is utilized. This appliance is equip

downloaded: 5   File size: 6 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces
@name

Hearth extensions are not required for these fireplaces. Louvers and decorative louver panels are interchangeable, and may be mixed and matched as desired. Attention: Flush panels may not be used on these models. Page 16 26670-0-0110 26670-0-0110 Page 17 The fireplace is designed to accept a gas line for connection to the gas valve. Have the line installed by a qualified service person in accordance with all building codes. Consult local building codes to properly size the gas supply line leadin

downloaded: 0   File size: 6 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces
@name

Sellers of unvented propane or natural gas-fired supplemental room heaters shall provide to each purchaser a copy of 527 CMR 30 upon sale of the unit. In the Sate of Massachusetts, unvented propane and natural gas-fired space heaters shall be prohibited in bedrooms and bathrooms. The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, International Fuel Gas Code, ANSI Z223.1.* *Available from the American National Standards Institute, In

downloaded: 0   File size: 6 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces
@name

This is an unvented gas-fired heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. Refer to page 8. Water Va por: A By-Product of Unvented Room Heaters Water vapor is a by-product of gas combustion. An unvented room heater produces approximately one (1) ounce (30ml) of water for every 1,000 BTU's (.3KW's) of gas input per hour. Refer to page 8. This appliance may be installed in an aftermarket, permanently l

downloaded: 6   File size: 2 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces
@name

Not enough fresh air is available for ODS/pilot to operate -Open window and/or door for ventilation. b. Low line pressure - Contact local gas company. c. ODS/pilot is partially clogged - Clean ODS/pilot. d. Defective thermocouple - Replace pilot. 4. Appliance shuts off during use. (Pilot stays on.) a. Low line pressure - Check line pressure to the valve. b. Defective thermopile -Check pilot flame, check wire connections,outputshouldbeaminimumof325millivolts across. TH/TP and TP terminals with ON

downloaded: 5   File size: 2 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces

downloaded: 77   File size: 2 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces

downloaded: 4   File size: 2 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces
@name

• If you are not qualified, do not light pilot lights, perform service, or make adjustments to appliances on the LP-Gas system. If you are qualified, consciously think about the odor of LP-Gas prior to and while lighting pilot lights or performing service or making adjustments. • Sometimes a basement or a closed-up house has a musty smell that can cover up the LP-Gas odor. Do not try to light pilot lights, perform service, or make adjustments in an area where the conditions are such that you may

downloaded: 3   File size: 3 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces
@name

20,000 BTUH Min. 7,000 BTUH VFHS-20/10T can be converted to 10,000 BTU for Bedroom Installation Max. 10,000 BTUH Min. 7,000 BTUH VFHS-20R Main Burner Operation The gas control modulates from a minimum input of 14,000 BTU/HR (LO setting) to a maximum input of 20,000 BTU/HR (HI setting). Cleaning and Maintenance / Main Burner Warning: Turn off heater and let cool before cleaning. Caution: You must keep control areas, burner and circulating air passageways of heater clean. Inspect these areas of he

downloaded: 13   File size: 3 mb   Manafacture: FireplaceXtrordinair  
Category: Fireplaces
@name

3. Place fireplace on top of base. 4. Gas line connections must be made at this time. When facing the fireplace the gas supply will enter on right-hand side. See "Gas Supply" Page 8. 5. Place right mantel side against base. Insert dowels in breastboard into right mantel side. Breastboard will rest on fireplace top and in front of nailing flange. Attention: Placing the breastboard in front of nailing flange will secure the fireplace. 6. Placeleftmantelsideagainstbase.Insertdowelsinbreastboard int





Category