Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  
downloaded: 5   File size: 3 kb   Manafacture: Genie  
Category: Mobility Aid

downloaded: 0   File size: 2 mb   Manafacture: Genie  
Category: Mobility Aid

downloaded: 4   File size: 641 kb   Manafacture: Genie  
Category: Mobility Aid
@name

Free-wheel Configuration for Winching Chock the wheels to prevent the machine from rolling. 2WD models: Release the non-steer wheel brakes by turning over the torque hub disconnect caps (see below). 4WD models: Release the wheel brakes by turning over all four torque hub disconnect caps (see below). Be sure the winch line is properly secured to the drive chassis tie points and the path is clear of all obstructions. Reverse the procedures described to re-engage the brakes. Note: The pump free-whe

downloaded: 3   File size: 641 kb   Manafacture: Genie  
Category: Mobility Aid
@name

12 Pull out the red Emergency Stop button to the on position. 13 Push and hold the lift function enable button. Push and hold the platform down button. Result: The platform should lower. 14 Turn the key switch to platform control and restart the engine. FUNCTION TESTS At the Platform Controls Test Emergency Stop 15 Push in the platform red Emergency Stop button to the off position. Result: No functions should operate. 16 Pull the red Emergency Stop button out to the on position. Result: The gree

downloaded: 3   File size: 641 kb   Manafacture: Genie  
Category: Mobility Aid
@name

It should be used only with adequate safety factors. Continuous improvement of our products is a Genie policy. Product specifications are subject to change without notice or obligation. PartNo.82828 Genie GS-3384 & GS-3390 & GS-4390 & GS-5390 Operator's Manual Second Edition • Third Printing SPECIFICATIONS GS-4390 Height, working maximum 15.1 m Height, platform maximum 13.1 m Height, stowed maximum 2.9 m Rails up Height, stowed maximum 2.9 m Rails lowered Width, standard tires 2.3 m Width, high-

downloaded: 28   File size: 641 kb   Manafacture: Genie  
Category: Mobility Aid
@name

If the light stays red, tag and remove the machine from service. OPERATING INSTRUCTIONS Indicator Light Flashing Red If the indicator light is flashing red, the platform is overloaded and no functions will operate. An alarm will sound at the platform controls. Remove weight from the platform. Push in and pull out the red Emergency Stop button to reset the system. If the platform is still overloaded, the light will continue to flash. To Extend and Retract Platform 1 Lift the platform extension lo

downloaded: 0   File size: 2 mb   Manafacture: Genie  
Category: Mobility Aid

downloaded: 4   File size: 2 mb   Manafacture: Genie  
Category: Mobility Aid
@name

Repairs to the machine may only be made by a qualified service technician, according to the manufacturer's specifications. After repairs are completed, the operator must perform a pre-operation inspection again before going on to the function tests. Scheduled maintenance inspections shall be performed by qualified service technicians, according to the manufacturer's specifications and the requirements listed in the responsibilities manual. PartNo.48643 Genie IWP Super Series Operator’s Manual Se

downloaded: 42   File size: 886 kb   Manafacture: Genie  
Category: Mobility Aid
@name

Genie GS-2032 and Genie GS-2632 Part No. 82784 Second Edition • Second Printing Operator's Manual Component Damage Hazard Do not use the machine as a ground for welding. Explosion and Fire Hazard Do not operate the machine in hazardous locations or locations where potentially flammable or explosive gases or particles may be present. Damaged Machine Hazards Do not use a damaged or malfunctioning machine. Conduct a thorough pre-operation inspection of the machine and test all functions before each

downloaded: 5   File size: 886 kb   Manafacture: Genie  
Category: Mobility Aid
@name

5 Observe the diagnostic LED readout. Result: LED should read 23 or --. Test Emergency Stop 6 Push in the ground red Emergency Stop button to the off position. Result: No functions should operate. 7 Pull out the red Emergency Stop button to the on position. Test the Up/Down Functions The audible warnings on this machine and the standard horn all come from the same central alarm. The horn is a constant tone. The descent alarm sounds at 60 beeps per minute. The alarm that goes off when the pothole





Category