Result: The up/down function should not operate. 12 Genie Lift Part No. 35566 First Edition • Sixth Printing Operator's Manual Workplace Inspection Do Not Operate Unless: You learn and practice the principles of safe machine operation contained in this operator's manual. 1 Avoid hazardous situations. 2 Always perform a pre-operation inspection. 3 Always perform function tests prior to use. 4 Inspect the workplace. Know and understand the workplace inspection before going on to the next section.

Avoid spilling or contacting battery acid. Neutralize battery acid spills with baking soda and water. The battery pack must remain in an upright position. Genie Lift Part No. 35566 First Edition • Sixth Printing Operator's Manual Explosion Hazards Batteries emit explosive gas. Keep sparks, flames and lighted tobacco away from the battery. Charge the battery in a well-ventilated area. Do not disconnect the charger DC output wires from the battery when the charger is on. Electrocution Hazards Conn

Do not stand or sit on the forks, load platform or boom. Do not climb on the machine. Tip-over Hazards Do not exceed the rated load capacity. See Load Capacity Charts section. Do not raise the load unless the leg lock pins have been properly inserted into the legs. Do not raise the load unless the correct length legs are properly installed. Do not raise the load unless the machine is on a firm, level surface. Do not move the machine with a raised load, except for minor positioning. Do not tilt t

Do not fill to maximum level until the battery charge cycle is complete. Overfilling can cause the battery acid to overflow during charging. Neutralize battery acid spills with baking soda and water. 3 Install the battery vent caps. 4 Charge the battery. 5 Check the battery acid level when the charging cycle is complete. Replenish with distilled water to the bottom of the fill tube. Do not overfill. 16 Genie Lift Part No. 35566 First Edition • Sixth Printing Operator's Manual Transport Instructi

5 Observe the diagnostic LED readout. Result: LED should read 23 or --. Test Emergency Stop 6 Push in the ground red Emergency Stop button to the off position. Result: No functions should operate. 7 Pull out the red Emergency Stop button to the on position. Test the Up/Down Functions The audible warnings on this machine and the standard horn all come from the same central alarm. The horn is a constant tone. The descent alarm sounds at 60 beeps per minute. The alarm that goes off when the pothole

Genie GS-2032 and Genie GS-2632 Part No. 82784 Second Edition • Second Printing Operator's Manual Component Damage Hazard Do not use the machine as a ground for welding. Explosion and Fire Hazard Do not operate the machine in hazardous locations or locations where potentially flammable or explosive gases or particles may be present. Damaged Machine Hazards Do not use a damaged or malfunctioning machine. Conduct a thorough pre-operation inspection of the machine and test all functions before each