Votes - 4, Average rating: 3.8
(
)
)
|
Other manuals for this model:
manual abstract
When you turn clockwise ( ), the door goes up. . WRENCH Adjustment part . NUT . BOLT Adjustment part . WRENCH . NUT . BOLT . NUT . BOLT . WRENCH . WRENCH . WRENCH . BOLT . BOLT Please open the doors and adjust the doors as follows: 1) Release the nut () on the lower hinge until the upper end of the bolt (.). When you release the nut(), use enclosed hex wrench (.) to turn the bolt(.) a little counterclockwise to make the nut() loose with your fingers. . BOLT . WRENCH . NUT NOTE NOTE CHECKING THE WATER DISPENSER LINE 1) In order to operate the ice maker properly, water pressure of 20 ~125 psi is required. In this range a 170 cc paper cup can be filled in 10 secs. 2) The water filter removes particles. It does not sterilize or destroy any micro-organisms. 3) If the refrigerator is installed in area with low water pressure (below 20psi), you should install a booster pump to compensate for the low pressure. 4) Ensure the water storage tank inside the refrigerator is properly filled initially. Push the water dis penser lever until the water runs from the outlet. NOTE A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer recommends using a water supply kit containing copper tubing. INSTALLATION OF THE WATER DISPENSER LINE SEPARATION OF RED CAP STICKER (MONTH INDICATION) COVER FILTER (A) ALIGN THE INDICATION MARK WITH LOCK POSITION. 1) As shown, the fixed cap separates from the refrigerator by rotating it counterclockwise. Remove the water filter from the box and put a month indicator sticker on the filter as shown. 2) If the water filter was installed in March, put on the "SEP" sticker. 3) Remove the protective cap then position and insert the filter as shown. 4) Slowly turn the water filter clockwise 90. to align the indication mark on the cover, locking the filter in posi tion. Do not overtighten. Please check that the indication line aligns with the lock position. Install the water filter. NOTE 1) Slip the compression nut and plastic ferrule through the plastic tube. 2) After inserting the sleeve, tighten the compression nut onto 1/4” compression fitting(union). Connect the water line to the refrigerator. Water line must be connected to drinkable water only Do not overtighten the compression NOTE nut. Keep the cap(A) in a safe place for recapping, when NOTE you will not use the filter. NOTE 3) Slip the compression ferrule and nut on copper (or plastic) tubing as shown. Tighten the comperssion nut onto the compression fitting(union). 4) Turn water on and check for any leakege. Compression Nut Compression fitting Sleeve Compression Nut Ferrule Ferrule ICE WATER 2) When you press the test button, the ice cube container is filled with water from the water supply tap. Check the amount of water (see the illustration below). If the water level is too low, the ice cubes will be small. This is not a problem with the ice maker but of the water pressure in the pipe, and occurs frequently. When this problem occur...
Other models in this manual:Refrigerators - 24KLDW (2.07 mb)
Refrigerators - RS21FANS (2.07 mb)
Refrigerators - RS24DAMS (2.07 mb)
Refrigerators - RS24DANS (2.07 mb)