Votes - 2, Average rating: 4.5
(
)
)
|
manual abstract
Start up Operation Spray lance with pressure regulation Spray lance with Dirtblaster Operation with detergent Recommended cleaning method • Spray the detergent sparingly on the dry surface and allow it to react, but not to dry. • Spray off loosened dirt with the high- pressure jet. Interrupting operation • Release the lever on the trigger gun. • Lock the lever on the trigger gun. • During longer breaks (more than 5 minutes), also turn the appliance off using the "0/OFF" switch. Finish operation Caution Only separate the high-pressure hose from the trigger gun or the appliance while there is no pressure in the system. • After working with detergent, suspend detergent suction hose in a container filled with clear water, switch the appliance on for around 1 minute once the spray lance has been removed and rinse until water runs clear. • Release the lever on the trigger gun. • Turn off the appliance "0/OFF". • Turn off tap. • Detach the appliance from the water supply. • Press the lever on the trigger gun to release any remaining pressure in the system. • Lock the lever on the trigger gun. • Pull out the mains plug. • Roll up the power cord and loop it e.g. round the handle. • Stow away the accessories in the accessory holder. Maintenance and care . Danger Turn off the appliance and remove the mains plug prior to any care and maintenance work. Maintenance The appliance is maintenance-free. Storage Prior to longer periods of storage, e.g. in the winter: • Completely drain all water from the appliance: Switch the appliance on with detached high-pressure hose and detached water supply (max. 1 minute) and wait, until no more water exits at the high-pressure connection. Turn off the appliance. • Remove filter from suction hose for detergent and clean under running water. • Pull out the sieve in the water connection using flat-nose pliers and clean under running water. Frost protection Caution Protect the appliance and its accessories against frost. The appliance and its accessories can get destroyed through frost if there are any water residues in them. To avoid damage to them: • Store the appliance and the entire accessories in a frost-safe room. Spare parts Use only original KARCHER spare parts. You will find a list of spare parts at the end of these operating instructions. 8 English Troubleshooting Troubleshooting You can rectify minor faults yourself with the help of the following overview. If in doubt, please consult the authorized customer service. . Danger Turn off the appliance and remove the mains plug prior to any care and maintenance work. Repair works may only be performed by the authorized customer service. Appliance is not running • Pull on the lever of the trigger gun; the device will switch on. • Check whether the voltage indicated on the type plate corresponds to the voltage of the mains supply. • Check the mains connection cable for damages. Pressure does not build up in the appliance • Check setting at the spray lance. • Appliance ventilation: Switch the appliance on with the high-pressure hose detached and operate (max. 2 minutes) until the water exits the high-pressure connection without bubbles. Switch off appliance and reconnect high-pressure hose. • Check the water supply. • Pull out the sieve in the water connection using flat-nose pliers and clean under running water. Appliance does not start, motor hums Cause: Voltage reduction due to weak mains supply or when using an extension cable. • When switching on, first pull the lever of the trigger gun and then switch the appliance switch to "I/ON". Strong pressure fluctuations • Clean high-pressure nozzle: Remove dirt and debris from the nozzle bore, using a needle and rinse through with water from the front. • Check water flow quantity. Appliance is leaking • Slight leakage from the appliance pump is normal. If the leakage increases contact the authorized customer service. No detergent infeed • Use spray lance with pressure regulation (Vario Power). Turn the spray lance to "Mix" position. • Clean the detergent suction hose filter. • Check the detergent suction hose for kinks. Technical specifications Power connection Voltage 240 V 1~50 Hz Connected load 1,7 kW Mains fuse (slow-blow) 10 A Protective class I Protection class IP X5 Water connection Max. feed temperature 40 °C Min. feed volume 10 I/min Max. feed pressure 1,2 MPa Max. Suction height 0,5 m Performance data Working pressure 11 MPa Max. permissible pressure 12 MPa 1740 MPa Water flow rate 6,3 I/min Detergent flow rate 0,3 I/min Subject to technical modifications! English 9 10 English i 08/2009 A Alfred Karcher Ges.m.b.H. Lichtblaustra.e 7 1220 Wien (01) 250 600. AUS Karcher Pty. Ltd. 40 Koornang Road Scoresby VIC 3179 (03) 9765 - 2300. B / LUX Karcher N.V. Industrieweg 12 2320 Hoogstraten .B: 0900 10027 LUX: 0032 900 10027 BR Karcher Industria e Comercio Ltda. Av. Prof. Benedicto Montenegro 419 CEP 13.140-000 - Paulinia - SP 0800 176 111. CDN Karcher Canada Inc. 6975 Creditview Road Un...