Login:
Votes - 4, Average rating: 4.5 ( )

User manual Field Controls, model UV-28HP

Manafacture: Field Controls
File size: 1.03 mb
File name:
Language of manual:en
Free link for this manual available at the bottom of the page



manual abstract


Be careful not to over tighten the wing nut. 6. Attach ballast plug onto the end of the lamp. 7. Plug in the power cord and press the power switch to the ON position. 8. Press the timer reset button on the circuit board using the eraser end of a pencil or the blunt end of a plastic ink pen. Hold for three seconds. (See Figure 22) 9. Release the timer reset button. The LED on the cover will flash twice, indicating the timer circuit has been reset. 10. Close cover and tighten cover screw. 11. After replacing lamp, make sure a new Lamp Replacement Label (supplied with lamp replacement) is applied to the housing and dated with the date of installation. TROUBLESHOOTING GUIDE 1. If the LED is illuminating a YELLOW color and the circuit board alarm beeps every 15 minutes, the lamp should be replaced soon. 2. If the LED is illuminating a RED color and the circuit board alarm beeps every 5 minutes, the lamp should be replaced immediately. 3. If the lamp does not light up, replace lamp. 4. If the lamp still does not light up after replacing the lamp, replace ballast. REPLACEMENT PARTS LIST Figure 22 MODEL LAMP (Field Controls Part Number) CIRCUIT BOARD (Field Controls Part Number) BALLAST (Field Controls Part Number) UV-12C 46365401 46436300 46365511 UV-18C 46365402 46436300 46365512 UV-28C 46365403 46436300 46365510 UV-28 46365403 N/A 46365503 UV-12HP 46365401 N/A 46365511 UV-18HP 46365402 N/A 46365512 UV-28HP 46365403 N/A 46365510 UV-12HPC 46365401 46436300 46365511 UV-18HPC 46365402 46436300 46365512 UV-28HPC 46365403 46436300 46365510 For replacement parts, contact your local heating service company. Any questions, please contact Field Controls at: • Phone: 252-522-3031 • Fax: 252-522-0214 • Email: sales@fieldcontrols.com WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness. Never operate the UV-Aire Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your hands. page 11 LIMITED WARRANTY Field Controls, LLC (“Company”) warrants that its products shall be free from defects in material and workmanship under normal use for the limited period indicated, from the date of manufacture, subject to the provisions 1-8 below. Eighteen (18) months All Field Controls Products (except for those listed below as 5 years or 90 days). Five (5) years Field Controls Direct Vent Systems (FDVS), Field Oil Vent Kits (FOVP), and ComboVents (CV). Field Controls warrants that the products listed below shall be free from defects in material and workmanship under normal use for the limited period indicated, from the date of purchase by the consumer, subject to the provisions 1-8 below. Ninety (90) days UV lamps/bulbs Provisions: 1. During the limited warranty period, Company, or its authorized service representative, will repair or replace, at Company’s option, without charge, a defective Product. Product that is repaired may be repaired with new or refu...

Other models in this manual:
Air Cleaners - UV-12HPC (1.03 mb)
Air Cleaners - UV-12C (1.03 mb)
Air Cleaners - UV-28HPC (1.03 mb)
Air Cleaners - UV-28C (1.03 mb)

Reviews



Your review
Your name:
Please, enter two numbers from picture:
capcha





Category