Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  
downloaded: 6   File size: 295 kb   Manafacture: Defy Appliances  
Category: Fans
@name

ceiling ceiling ceiling Page 3 Installation.. Installation.. Installation sequence; 1. Extractor unit / chimney brackets. 2. Top chimney duct 3. Bottom chimney duct • Carefully remove the extractor hood and the components from the packaging. • Remove the grease filters. CEILING MOUNTING TEMPLATE CEILING MOUNTING BRACKET POSITION CUT TEMPLATE TOP OF CEILING HOOD TEMPLATE LINE FROM CENTRE OF STOVE TO CEILING HORIZONTAL LINE 750 • Draw a fine vertical line on the wall from the rear-centre of the ho

downloaded: 15   File size: 442 kb   Manafacture: Defy Appliances  
Category: Fans
@name

DCH 253 900 C PREMIUM STAINLESS STEEL EXTRACTOR HOOD WITH CURVED GLASS. PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING AND OPERATING. The manufacturer strives for continuous improvements. For this reason, the text and illustrations in this book are subject to change without notice. Part Number 066471. INDEX 2 Description. 2 Before use. 2 Safety advice. 2 Electrical connection. 3 Preparing for installation. 3 Re-circulating filtered air. 3 Venting air to the outside. 4 Installation. 5

downloaded: 4   File size: 295 kb   Manafacture: Defy Appliances  
Category: Fans
@name

Electrical connection. • The extractor hood uses a 220250V/ 50Hz power supply. • If the mains power cord is damaged, it must be replaced by a qualified electrician. • The power cord is located in the chimney area. Should you require an installation with no visible wiring, a 15 amp earthed plug socket should be accessible either in the ceiling above the extractor hood or on the wall behind the chimney area. (A qualified electrician should provide this facility). • The extractor hood must be earth

downloaded: 1   File size: 295 kb   Manafacture: Defy Appliances  
Category: Fans
@name

holes through the top holes in the bottom chimney and through the lower end of the top chimney duct. • Fasten the two chimneys to the centre chimney bracket. Top chimney duct Drill two 3.5mm Diameter holes and secure two chimney ducts to mounting bracket. Mounting bracket Bottom chimney duct Page 5 Grease filters. Grease filters. • Remove the plastic outer protective lining on the grease filters before fitting them to the extractor hood. • To fit the filters, engage the two lugs at the rear of e

downloaded: 5   File size: 295 kb   Manafacture: Defy Appliances  
Category: Fans
@name

• Damage through improper use or installation. Problem check. Before calling a service technician to assist with a problem please check: • The main distribution board. See if a circuit breaker has tripped or a fuse has blown. • The wall socket. • Have the filters been cleaned? • Is the chimney blocked? Remember that you may be charged for a service call even during the warranty period if the fault is due to or caused by any of the above. Service. • If you have followed the instructions and still





Category