Votes - 0, Average rating: 5 ( )

Manafacture: Delta Electronics File size: 978.31 kb File name: 264900EN.pdf Language of manual:

by pulling out the plug. Then plug it in again and try once more before contacting the Technical Assistance Service. Controls 31 Setting the fan speed (Fig- 8) Hood lighting (Fig- 8) Press the ([©]) button (F) to select the fan speed from 1 to 9, keeping it pressed until the speed you want, e.g. speed 5, is shown on the display (D). The red display LED (D) will come on. If you accidentally set a higher speed than you want, press the decrease speed button ([©]) (E) until the correct speed is shown on the display (D). Simply press the ([#]) button (A) to switch the lighting on or off. 32 ( ) [ D E E F r I o £ E |9 1 Intensive speed P (Fig. 9) To select the intensive speed (P), press the increase speed button ([©]) (F) until the letter P (high speed) is shown on the display (D). Press the ([©]) button (E) to slow down from intensive-speed operation. The speeds 9-1 will once again be shown on the display. If there is a high level of cooking fumes or vapour, the hood should be left in operation for at least 15 minutes after the cooker has been completely turned off. Press the ([X]) button (C) to switch on the fan timer. I will automatically switch off after 15 minutes operation at the speed you have selected. A red dot will flash on and off on the display (D). Fan timer (Fig- 9) 33 Switching off i the fan (Figures 10-11) Press the [oj key (B) to switch off the fan at any speed including P. B D [To I After 5 seconds the number “0” (Fig. 10) will be shown on the display (D) followed, finally, by only the red dot (Fig. 11). D BUZ] 34 The hood should always be switched on before you start cooking and left on for approximately 15 minutes after you have finished (fan timer [X]). The activated carbon filter should be replaced at least once every 120 operating hours. The activated carbon filter cannot be cleaned or reused. The effective elimination of cooking odours depends on the functional adaptation of the volume of activated carbon to the hood’s air flow and a carefully determined position of the filter inside the hood. This combination inevitably decreases the air flow compared to the extractor version. A decisive parameter for the elimination of cooking odours is what is known as the “residence time” of the air sucked into the hood in the activated carbon filter. The correct “residence time” can only be obtained using original AEG activated carbon filters (see Special Accessories). After 120 operating hours, the letter (C) (activated carbon filter) will flash on and off on the display (D) in alternation with the fan speed setting. This means the activated carbon filter needs to be changed! (This operation should be carried out every 120 operating hours!) Warning! The metal grease filters must be cleaned when you change the activated carbon filter. Hood operation before and after cooking Warnings on the activated carbon filter Display warning on saturation of activated carbon filter (Fig. 12) 35 Proceed a...

Download now

Please, enter two numbers from picture: