Votes - 0, Average rating: 0
(
)
)
|
manual abstract
In both cases, if you find that water is dripping out of the soleplate, set the temperature selector (11) to a higher position (take care that the garment can be ironed on this heat temperature setting). Cork handle iron (depending on the model): To get permanent steam, press the lock button (15) and slide it backwards until it locks. To switch off the permanent steam, slide the lock button forward. Important: • The steam hose may get hot if you are ironing for long periods. Ironing without steam 1.Set the required ironing temperature. 2.Begin ironing but without pressing the steam release button (12). Vertical steam (C) 1.Set the temperature control to the “••” or “max” position. 2.You can steam iron curtains and hanging garments (jackets, suits, coats...) by holding the iron in a vertical position and pressing the steam release button (12). Operate the iron vertically at a distance of 10 to 20 cm Never direct the steam jet at garments that are being worn. Never aim the steam at people or animals. Cleaning the Boiler To extend the life of your steam generator and to avoid any build up of scale, it is essential that you rinse out the boiler after several hours of use (approximately after 50 hours). If the water is hard, increase the frequency. Do not use descaling agents for rinsing out the boiler, as they could damage it. 1.Check that the appliance is unplugged and cold for more than 2 hours. 2.Unscrew the boiler.s cap (1) 3.Empty the boiler above a sink by holding the appliance upside down. 4.Fill the boiler with 500 ml of fresh water. 5.Shake the base unit for a few moments and then empty it completely over a sink or bucket. 6.To obtain the best result, we recommend that this operation is done twice 7.Close the cap enen Cleaning & Maintenance Important: Always unplug the appliance from the mains supply before carrying out any cleaning or maintenance operation on it. 1.After ironing, pull out the plug and allow the appliance to cool down before cleaning. 2.Wipe the housing, handle and iron body with a damp cloth. 3.If the soleplate is soiled with dirt or scale, clean it with a damp cloth. 4.Never use abrasive products or solvents. Storing the appliance (D) 1.Set the main power to the “0” position and disconnect the mains cable. 2.Always allow the appliance to cool down before storing it. 3.Place the iron on the iron pad, standing on the soleplate. 4.Empty the boiler and store the mains cable and the steam hose in the storage compartment. Do not wrap the cords too tight. Fabric protection soleplate cover (E) (depending on the model) The fabric-protection soleplate cover is used for steam-ironing delicate garments at maximum temperature without damaging them. Use of the soleplate cover also does away with the need for a cloth to prevent shine on dark materials. It is advisable to first iron a small section on the inside of the garment to see if it is suitable. Trouble shooting To attach the soleplate cover to the iron, place the tip of the iron i...
Other models in this manual:Irons - TDS1445/02 (6.1 mb)
Irons - TDS1445/03 (6.1 mb)
Irons - TDS1445/04 (6.1 mb)
Irons - TDS1445/06 (6.1 mb)