3.
Apply pressure evenly to both sides of the EEB
and slide it into the I/O management unit until
Remove the EEB blank plate (new
the latch hooks begin to move towards the middle
installation only)
of the EEB. Push the latch hooks towards the
middle of the EEB and into the lock position. You
1.
Lift the latch hooks of the blank plate out of the
will feel the EEB pins connect with the I/O
locked position and push them up and away from
management unit backplane as it locks into place.
the center of the blank plate.
4.
Push the latch hooks into the lock position, then
remove and discard the black rubber protective
covers from the ports on the EEB that will be
connected to drives immediately.
Connect the cables
1.
If this is a replacement EEB, reconnect the cables
to the appropriate ports on the EEB exactly as
they were connected to the previous EEB.
2.
If this is a new EEB installation, install the
associated drives and connect the cables to them
as follows:
Drive # (bottom
EEB
Port
Drive bay
to top)
Slot 8
Eth 6
Upper drive
12
(upper)
bay
Eth 5
11
Eth 4
10
Eth 3
9
Eth 2
8
1. Latch hooks
Eth 1
7
2.
Slide the blank plate out of the I/O management
Slot 7
Eth 6
Lower drive
6
unit.
(lower)
bay
Eth 5
5
Eth 4
4
Install the EEB
Eth 3
3
Eth 2
2
NOTE:
When replacing a blade, wait until
the library has detected that the previous blade
Eth 1
1
has been removed before installing the new
blade. The library should log an event on the
OCP within ten minutes. To view the event, on
the tool bar click the Events icon.
Prepare the library for use
1.
Press up and out to open the latch hooks on each
1.
Detach the ESD strap and close the door.
side of the new EEB.
2.
Put all drives connected to the EEB back into an
2.
Carefully align the EEB with the guide slots in the
online state using the ‘Vary on’ operation:
I/O management unit.
a.
From the OCP, select Tools→Drives.
CAUTION:
Forcing the EEB into the I/O
b.
In the Drive(s) table, click to highlight the
management unit can cause the pins to
drive to vary on.
bend.
c.
Click Vary On.
Page 3

---

...

Other models in this manual:
Media Storage - HP StoreEver ESL G3 300 slot Tape Library (151.1 kb)
Media Storage - HP StoreEver ESL G3 700 slot Tape Library (151.1 kb)
Media Storage - HP StoreEver ESL G3 1500 slot Tape Library (151.1 kb)
Media Storage - HP StoreEver ESL G3 3000 slot Tape Library (151.1 kb)