Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
Figure 3 Installing the rails
Installing the X9730 CX into the rack
WARNING!
The X9730 CX with no drives
installed weighs 72.58 kg (160.00 lb). With
all drives and components installed, the X9730
CX can weigh up to 145.15 kg (320 lb). Before
1
2
configuring your rack solution, be sure to check
the manufacturer weight limits and
specifications. Failure to do so can result in
physical injury or damage to the equipment and
3
the facility.
CAUTION:
•
Always plan the rack installation so that the
4.
Repeat the procedure for the right rack rail.
heaviest item is on the bottom of the rack.
5.
Install the X9730 CX.
Install the heaviest item first, and continue
to populate the rack from the bottom to the
WARNING!
The X9730 CX is very heavy.
top.
To reduce the risk of personal injury or
•
HP has not tested or validated the X9730
damage to the equipment:
CX with any third-party racks. Before
•
Observe local occupational health and
installing the X9730 CX in a third-party
safety requirements and guidelines for
rack, be sure to properly scope the
manual material handling.
limitations of the rack. Before proceeding
•
Remove all installed components from
with the installation, consider the following:
the X9730 CX before installing or
◦ You must fully understand the static and
moving the X9730 CX.
dynamic load carrying capacity of the
•
Use caution and get help to lift and
rack and be sure that it can
stabilize the X9730 CX during
accommodate the weight of the X9730
installation or removal, especially
CX.
when the X9730 CX is not fastened to
◦
the rack.
Be sure sufficient clearance exists for
cabling, installation and removal of the
Always use at least two people to lift an
enclosure, actuation of the rack doors,
enclosure into the rack. If the enclosure is
and full articulation of the drive
being loaded into the rack above chest
drawers.
level, a third person must assist with
aligning the enclosure with the rails while
The rack rails are marked for easy identification. The
the other two people support the weight of
left rack rail is marked "L" and the right rack rail is
the enclosure.
marked "R."
1.
Begin with the left rack rail. Align the end of the
6.
Tighten the thumbscrews to secure the X9730 CX
rail with the rear rack column.
to the rack.
2.
Slide the rack rail closed until the end of the rail
is locked in place, wrapping behind the rear rack
column.
3.
Slide the front end of the rail to the rack front
column. When fully seated, the rack rail will lock
into place.
Page 3
...Other models in this manual:
Media Storage - HP IBRIX X9320 10GbE Performance Block (3.95 mb)
Media Storage - HP IBRIX X9320 IB Performance Block (3.95 mb)
Media Storage - HP StoreAll 8800 Storage Node (3.95 mb)
Media Storage - HP StoreAll 9320 1GbE Storage Node Pair (3.95 mb)