Votes - 0, Average rating: 0
(
)
)
|
manual abstract
HP StorageWorks
About this document
controller enclosure cache
This document provides the procedure for replacing a controller
battery replacement instructions
cache battery in EVA4x00/6x00/8x00 products, with the
exception of the EVA4400. For the latest documentation, go to
ht p://www.hp.com/support/manuals, and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT: To obtain a copy of the warranty for this
product, see the warranty information website:
ht p://www.hp.com/go/storagewarranty
These instructions apply to the EVA4000, 4100,
Before you begin
6000, 6100, 6400, 8000, 8100, and 8400
Observe the following precautions when replacing a cache battery.
products.
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection.
NOTE:
The quantity of instal ed cache batteries varies with EVA models.
Two battery slots are located at the left front of the controller
enclosure. Two additional battery slots are located behind the
operator control panel (OCP).
© Copyright 2009 Hewlett-Packard Development Company, L.P.
Sixth edition: March 2009
The information in this document is subject to change without
Verifying component failure
notice.
Use the following methods to verify component failure:
Printed in Puerto Rico
CAUTION:
www.hp.com
If HP Command View EVA does not present a status consistent with
the battery status indicator, or if either HP Command View EVA or
your system monitoring tool indicates multiple hardware failures,
contact HP support for assistance (ht p://www.hp.com/support).
• Analyze any failure messages received. Fault monitoring software
from HP (WEBES) provides a recommended solution.
• Check status using HP Command View EVA:
1. In the navigation pane, select Storage system > Hardware >
Rack > Controller Enclosure > Controller.
NOTE:
The EVA6400/8400 does not have a Rack selection in
the navigation pane.
2. In the Content pane, select the Enclosure tab. The status is
displayed in the Cache Battery Modules field. The status should
be
(Failed).
*531236-001*
Page 1
...Other models in this manual:
Media Storage - HP 6100 Enterprise Virtual Array (156.81 kb)
Media Storage - HP 8100 Enterprise Virtual Array (156.81 kb)
Media Storage - HP EVA4000 Starter Kit (156.81 kb)
Media Storage - HP EVA4000/6000/8000 Disk Arrays (156.81 kb)