Votes - 0, Average rating: 0
(
)
)
|
Other manuals for this model:
manual abstract
HP StorageWorks
About this document
2312/2324 Modular Smart
This document details procedures for replacing a failed DC power
Array DC power supply
supply in an HP StorageWorks 2000 Family Modular Smart Array.
replacement instructions
Before you begin
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection:
• Keep the replacement component in the ESD bag until needed
• Wear an ESD wrist strap grounded to an unpainted surface
of the chassis.
• If an ESD wrist strap is unavailable, touch an unpainted surface
of the chassis before handling the component.
• Never touch connector pins.
Verifying component failure
Check the DC Voltage/Fan Fault/Service Required (bottom) LED:
• Amber = Fault condition
Disconnecting a DC power cable
IMPORTANT:
Use only the DC power cables provided with your product.
© Copyright 2008 Hewlett-Packard Development Company, L.P.
First edition: November, 2008
1. Verify that the main breaker to the rack is shut off prior to
The information in this document is subject to change without
disconnecting any DC connections.
notice.
2. Verify that al enclosure power switches are off.
Printed in China
3. Loosen the cable-locking screws at aching the D-shell connector to
www.hp.com
the power supply.
4. Disconnect the power cable from the power supply.
5. Turn on the main breaker to the rack.
Removing a power supply
1. Turn the thumbscrew until it is disengaged from the module.
2. Rotate the latch downward to disconnect the internal connector,
and slide the module out.
500919-001
Page 1
...