Votes - 4, Average rating: 4.3 ( )

Manafacture: Bosch File size: 129.06 kb File name: a14bcc24-c076-4bb6-98a9-4ddf0768f3b0.pdf Language of manual:

To avoid restricting the outlet, maintain a minimum of 12 inches (30.5 cm) clearance between the vent hood and the ground or any other obstruction. The vent flap should be able to move freely. MAXIMUM EXHAUST LENGTH 14 GDZ22-1 manual 10/22/01 11:45 AM Page 16 English After installation is completed, the following method must be used to determine if the exhaust system is acceptable: 1. Connect an inclined or digital manometer between the dryer and the point the exhaust connects to the dryer. 2. Set the dryer timer and temperature to air fluff (cool down) and start the dryer. 3. Read the measurement on the manometer. 4. The system back pressure must not be higher than 0.75 inches of water column. If the system back pressure is less than 0.75 inches of water column, the system is acceptable. If the manometer reading is higher than 0.75 inches of water column, the system is too restrictive and the installation is unacceptable. Although vertical orientation of the exhaust system is acceptable, certain extenuating circumstances could affect the performance of the dryer: 1. Only the rigid metal duct work should be used. 2. Venting vertically through a roof may expose the exhaust system to down drafts causing an increase in vent restriction. 3. Running the exhaust system through an area not insulated may cause condensation and faster accumulation of lint. 4. Compression or crimping of the exhaust system will cause an increase in vent restriction. The exhaust system should be inspected and cleaned a minimum of every 18 months with normal usage. The more the dryer is used, the more often you should check the exhaust system and vent hood for proper operation. 15 GDZ22-1 manual 10/22/01 11:45 AM Page 17 English Location of Your Dryer Do Not Install Your Dryer: • In an area exposed to dripping water or outside weather conditions. • In an area where it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion and ventilation air. • On carpet. Floor must be solid with a maximum slope of 1inch (2.54 cm). Installation in Recess or Closet: • A dryer installed in a bedroom, bathroom, recess or closet, must be exhausted outdoors. • Your dryer needs the space around it for proper ventilation. • A minimum of 120 square inches (774.2 square cm) of opening, equally divided at the top and bottom of the door, is required. Air openings are required to be unobstructed when a door is installed. A louvered door with equivalent air openings for the full length of the door is acceptable. ROUGH-IN DIMENSIONS 16 GDZ22-1 manual 10/22/01 11:45 AM Page 18 English Installation in Mobile Home • Dryer must be exhausted outside (outdoors, not beneath the mobile home) using metal ducting that will not support combustion. Metal ducting must be 4 inches (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. • If dryer is exhausted through the floor and area beneath the mobile home is enclosed, the exhaust system must terminate outside the enclosure with the termination securely fastened to the mobile home structure. • Refer to previous pages for other important venting requirements. • Installation must conform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is not applicable, with American National Standard for Mobile Homes. Warning: The dryer is designed under ANSI z 21.5.1 for home use only. DO DON’T Correct Incorrect DO DON’T Correct Incorrect DO DON’T Correct Incorrect 17 GDZ22-1 manual 10/22/01 11:45 AM Page 19 English Electrical Connections Requirements and Instructions WARNINGS The following are specific requirements for proper and safe instructions can create electrical shock and/or fire hazard. electrical installation of your dryer. Failure to follow these 1. This appliance must be properly grounded. Electrical shock can result if the dryer is not properly grounded. Follow the instructions in this manual for proper grounding. 2. Do not use an extension cord with...

Download now

Please, enter two numbers from picture: